The driver uses a static XFER_TIMEOUT of HZ (1 second) for all transfers regardless of message length or bus frequency, causing unnecessary delays on error paths.

Compute the timeout dynamically from message length and bus frequency with a 10x safety margin over the theoretical wire time. Add a 300 ms floor to account for I2C clock stretching and other situations where a slave may keep SCL asserted for an extended period, including faulty devices holding the bus.

This replaces the fixed 1-second timeout with a transfer-specific timeout while preserving sufficient margin for software overheads and bus-level delays.

For GPI multi-descriptor transfers, use the maximum message length across all queued messages as the per-completion timeout.

Signed-off-by: Aniket Randive aniket.randive@oss.qualcomm.com ---

Changes in V5: - Updated the commit message as per the review comments.

Changes in V4: - As per konrad suggestion used mult_frac() for bit_usec to avoid intermediate overflow on 32-bit targets. - Updated the commit message and added a driver comment explaining the rationale for the 0.3-second minimum timeout floor value.

drivers/i2c/busses/i2c-qcom-geni.c | 47 +++++++++++++++++++++++------- 1 file changed, 37 insertions(+), 10 deletions(-)

diff --git a/drivers/i2c/busses/i2c-qcom-geni.c b/drivers/i2c/busses/i2c-qcom-geni.c index 96dbf04138be..f011d2564cd2 100644 --- a/drivers/i2c/busses/i2c-qcom-geni.c +++ b/drivers/i2c/busses/i2c-qcom-geni.c @@ -74,9 +74,14 @@ enum geni_i2c_err_code { #define PACKING_BYTES_PW 4

#define ABORT_TIMEOUT HZ -#define XFER_TIMEOUT HZ #define RST_TIMEOUT HZ

+/* 9 bits per byte (8 data + 1 ACK), 10x safety margin */ +#define I2C_TIMEOUT_SAFETY_COEFFICIENT 10 + +/* 300ms floor: budget for clock stretching; slave may hold SCL low indefinitely */ +#define I2C_TIMEOUT_MIN_USEC 300000 + struct geni_i2c_desc { bool no_dma_support; unsigned int tx_fifo_depth; @@ -204,6 +209,16 @@ static int geni_i2c_clk_map_idx(struct geni_i2c_dev *gi2c) return -EINVAL; }

+static unsigned long geni_i2c_xfer_timeout(struct geni_i2c_dev *gi2c, size_t len) +{ + size_t bit_cnt = len * 9; + size_t bit_usec = mult_frac(bit_cnt, USEC_PER_SEC, gi2c->clk_freq_out); + size_t xfer_max_usec = (bit_usec * I2C_TIMEOUT_SAFETY_COEFFICIENT) + + I2C_TIMEOUT_MIN_USEC; + + return usecs_to_jiffies(xfer_max_usec); +} + static int qcom_geni_i2c_conf(struct geni_se *se, unsigned long freq) { struct geni_i2c_dev *gi2c = dev_get_drvdata(se->dev); @@ -445,7 +460,7 @@ static int geni_i2c_rx_one_msg(struct geni_i2c_dev *gi2c, struct i2c_msg *msg, u32 m_param) { dma_addr_t rx_dma = 0; - unsigned long time_left; + unsigned long time_left, timeout; void *dma_buf; struct geni_se *se = &gi2c->se; size_t len = msg->len; @@ -470,8 +485,9 @@ static int geni_i2c_rx_one_msg(struct geni_i2c_dev *gi2c, struct i2c_msg *msg, gi2c->dma_buf = dma_buf; }

+ timeout = geni_i2c_xfer_timeout(gi2c, len); cur = gi2c->cur; - time_left = wait_for_completion_timeout(&gi2c->done, XFER_TIMEOUT); + time_left = wait_for_completion_timeout(&gi2c->done, timeout); if (!time_left) geni_i2c_abort_xfer(gi2c);

@@ -484,7 +500,7 @@ static int geni_i2c_tx_one_msg(struct geni_i2c_dev *gi2c, struct i2c_msg *msg, u32 m_param) { dma_addr_t tx_dma = 0; - unsigned long time_left; + unsigned long time_left, timeout; void *dma_buf; struct geni_se *se = &gi2c->se; size_t len = msg->len; @@ -512,8 +528,9 @@ static int geni_i2c_tx_one_msg(struct geni_i2c_dev *gi2c, struct i2c_msg *msg, if (!dma_buf) /* Get FIFO IRQ */ writel_relaxed(1, se->base + SE_GENI_TX_WATERMARK_REG);

+ timeout = geni_i2c_xfer_timeout(gi2c, len); cur = gi2c->cur; - time_left = wait_for_completion_timeout(&gi2c->done, XFER_TIMEOUT); + time_left = wait_for_completion_timeout(&gi2c->done, timeout); if (!time_left) geni_i2c_abort_xfer(gi2c);

@@ -591,7 +608,7 @@ static void geni_i2c_gpi_multi_desc_unmap(struct geni_i2c_dev *gi2c, struct i2c_ * geni_i2c_gpi_multi_xfer_timeout_handler() - Handles multi message transfer timeout * @dev: Pointer to the corresponding dev node * @multi_xfer: Pointer to the geni_i2c_gpi_multi_desc_xfer - * @transfer_timeout_msecs: Timeout value in milliseconds + * @transfer_timeout_msecs: Per-message completion timeout in jiffies * @transfer_comp: Completion object of the transfer * * This function waits for the completion of each processed transfer messages @@ -601,7 +618,7 @@ static void geni_i2c_gpi_multi_desc_unmap(struct geni_i2c_dev *gi2c, struct i2c_ */ static int geni_i2c_gpi_multi_xfer_timeout_handler(struct device *dev, struct geni_i2c_gpi_multi_desc_xfer *multi_xfer, - u32 transfer_timeout_msecs, + unsigned long timeout_jiffies, struct completion *transfer_comp) { int i; @@ -612,7 +629,7 @@ static int geni_i2c_gpi_multi_xfer_timeout_handler(struct device *dev,

if (multi_xfer->msg_idx_cnt != multi_xfer->irq_cnt) { time_left = wait_for_completion_timeout(transfer_comp, - transfer_timeout_msecs); + timeout_jiffies); if (!time_left) { dev_err(dev, "%s: Transfer timeout\n", __func__); return -ETIMEDOUT; @@ -736,8 +753,16 @@ static int geni_i2c_gpi(struct geni_i2c_dev *gi2c, struct i2c_msg msgs[], dma_async_issue_pending(gi2c->tx_c);

if ((msg_idx == (gi2c->num_msgs - 1)) || flags & DMA_PREP_INTERRUPT) { + unsigned long timeout; + size_t max_len = 0; + int j; + + for (j = 0; j < gi2c->num_msgs; j++) + max_len = max_t(size_t, max_len, msgs[j].len); + + timeout = geni_i2c_xfer_timeout(gi2c, max_len); ret = geni_i2c_gpi_multi_xfer_timeout_handler(gi2c->se.dev, gi2c_gpi_xfer, - XFER_TIMEOUT, &gi2c->done); + timeout, &gi2c->done); if (ret) { dev_err(gi2c->se.dev, "I2C multi write msg transfer timeout: %d\n", @@ -851,8 +876,10 @@ static int geni_i2c_gpi_xfer(struct geni_i2c_dev *gi2c, struct i2c_msg msgs[], i }

if (!gi2c->is_tx_multi_desc_xfer) { + unsigned long timeout = geni_i2c_xfer_timeout(gi2c, msgs[i].len); + dma_async_issue_pending(gi2c->tx_c); - time_left = wait_for_completion_timeout(&gi2c->done, XFER_TIMEOUT); + time_left = wait_for_completion_timeout(&gi2c->done, timeout); if (!time_left) { dev_err(gi2c->se.dev, "%s:I2C timeout\n", __func__); gi2c->err = -ETIMEDOUT;