For both the old bindings and the new bindings the same logic was applied to retrieve the number of CS lines: using of_get_property() to get a size in bytes, converted in the actual number of lines by dividing it per sizeof(u32) (4 bytes).

This is fine for the 'reg' property which is a list of the CS IDs but not for the 'num-cs' property which is directly the value of the number of CS.

Anyway, no existing DT uses another value than 'num-cs = <1>' and no other value has ever been supported by the old driver (pxa3xx_nand.c). Remove this condition and apply a number of 1 CS anyway, as already described in the bindings.

Fixes: 02f26ecf8c772 ("mtd: nand: add reworked Marvell NAND controller driver") Cc: stable@vger.kernel.org Signed-off-by: Miquel Raynal miquel.raynal@bootlin.com --- drivers/mtd/nand/raw/marvell_nand.c | 14 ++++---------- 1 file changed, 4 insertions(+), 10 deletions(-)

diff --git a/drivers/mtd/nand/raw/marvell_nand.c b/drivers/mtd/nand/raw/marvell_nand.c index 2a467c72bbfb..c33ebc2cc024 100644 --- a/drivers/mtd/nand/raw/marvell_nand.c +++ b/drivers/mtd/nand/raw/marvell_nand.c @@ -2299,29 +2299,23 @@ static int marvell_nand_chip_init(struct device *dev, struct marvell_nfc *nfc, /* * The legacy "num-cs" property indicates the number of CS on the only * chip connected to the controller (legacy bindings does not support - * more than one chip). CS are only incremented one by one while the RB - * pin is always the #0. + * more than one chip). The CS and RB pins are always the #0. * * When not using legacy bindings, a couple of "reg" and "nand-rb" * properties must be filled. For each chip, expressed as a subnode, * "reg" points to the CS lines and "nand-rb" to the RB line. */ - if (pdata) { + if (pdata || nfc->caps->legacy_of_bindings) { nsels = 1; - } else if (nfc->caps->legacy_of_bindings) { - if (!of_get_property(np, "num-cs", &nsels)) { - dev_err(dev, "missing num-cs property\n"); - return -EINVAL; - } } else { if (!of_get_property(np, "reg", &nsels)) { dev_err(dev, "missing reg property\n"); return -EINVAL; } - }

- if (!pdata) nsels /= sizeof(u32); + } + if (!nsels) { dev_err(dev, "invalid reg property size\n"); return -EINVAL;