If no NVM file matches the board_id, load the default NVM file.

Cc: stable@vger.kernel.org Signed-off-by: Shuai Zhang quic_shuaz@quicinc.com --- drivers/bluetooth/btusb.c | 26 +++++++++++++++++--------- 1 file changed, 17 insertions(+), 9 deletions(-)

diff --git a/drivers/bluetooth/btusb.c b/drivers/bluetooth/btusb.c index dcbff7641..020dbb0ab 100644 --- a/drivers/bluetooth/btusb.c +++ b/drivers/bluetooth/btusb.c @@ -3482,15 +3482,14 @@ static int btusb_setup_qca_load_rampatch(struct hci_dev *hdev, }

static void btusb_generate_qca_nvm_name(char *fwname, size_t max_size, - const struct qca_version *ver) + const struct qca_version *ver, + u16 board_id) { u32 rom_version = le32_to_cpu(ver->rom_version); const char *variant, *fw_subdir; int len; - u16 board_id;

fw_subdir = qca_get_fw_subdirectory(ver); - board_id = qca_extract_board_id(ver);

switch (le32_to_cpu(ver->ram_version)) { case WCN6855_2_0_RAM_VERSION_GF: @@ -3517,14 +3516,14 @@ static void btusb_generate_qca_nvm_name(char *fwname, size_t max_size,

static int btusb_setup_qca_load_nvm(struct hci_dev *hdev, struct qca_version *ver, - const struct qca_device_info *info) + const struct qca_device_info *info, + u16 board_id) { const struct firmware *fw; char fwname[80]; int err;

- btusb_generate_qca_nvm_name(fwname, sizeof(fwname), ver); - + btusb_generate_qca_nvm_name(fwname, sizeof(fwname), ver, board_id); err = request_firmware(&fw, fwname, &hdev->dev); if (err) { bt_dev_err(hdev, "failed to request NVM file: %s (%d)", @@ -3606,10 +3605,19 @@ static int btusb_setup_qca(struct hci_dev *hdev) btdata->qca_dump.controller_id = le32_to_cpu(ver.rom_version);

if (!(status & QCA_SYSCFG_UPDATED)) { - err = btusb_setup_qca_load_nvm(hdev, &ver, info); - if (err < 0) - return err; + u16 board_id = qca_extract_board_id(&ver);

+ err = btusb_setup_qca_load_nvm(hdev, &ver, info, board_id); + if (err < 0) { + //if the board id is not 0, try to load the defalut nvm file + if (err == -ENOENT && board_id != 0) { + err = btusb_setup_qca_load_nvm(hdev, &ver, info, 0); + if (err < 0) + return err; + } else { + return err; + } + } /* WCN6855 2.1 and later will reset to apply firmware downloaded here, so * wait ~100ms for reset Done then go ahead, otherwise, it maybe * cause potential enable failure.