The code is doing monolithic reads for all chunks except the last one which is wrong since a monolithic read will issue the READ0+ADDRS+READ_START sequence. It not only takes longer because it forces the NAND chip to reload the page content into its internal cache, but by doing that we also reset the column pointer to 0, which means we'll always read the first chunk instead of moving to the next one.

Rework the code to do a monolithic read only for the first chunk, then switch to naked reads for all intermediate chunks and finally issue a last naked read for the last chunk.

Fixes: 02f26ecf8c77 mtd: nand: add reworked Marvell NAND controller driver Cc: stable@vger.kernel.org Reported-by: Chris Packham chris.packham@alliedtelesis.co.nz Signed-off-by: Boris Brezillon boris.brezillon@bootlin.com Tested-by: Chris Packham chris.packham@alliedtelesis.co.nz --- drivers/mtd/nand/raw/marvell_nand.c | 8 +++++--- 1 file changed, 5 insertions(+), 3 deletions(-)

diff --git a/drivers/mtd/nand/raw/marvell_nand.c b/drivers/mtd/nand/raw/marvell_nand.c index db5ec4e8bde9..ebb1d141b900 100644 --- a/drivers/mtd/nand/raw/marvell_nand.c +++ b/drivers/mtd/nand/raw/marvell_nand.c @@ -1194,11 +1194,13 @@ static void marvell_nfc_hw_ecc_bch_read_chunk(struct nand_chip *chip, int chunk, NDCB0_CMD2(NAND_CMD_READSTART);

/* - * Trigger the naked read operation only on the last chunk. - * Otherwise, use monolithic read. + * Trigger the monolithic read on the first chunk, then naked read on + * intermediate chunks and finally a last naked read on the last chunk. */ - if (lt->nchunks == 1 || (chunk < lt->nchunks - 1)) + if (chunk == 0) nfc_op.ndcb[0] |= NDCB0_CMD_XTYPE(XTYPE_MONOLITHIC_RW); + else if (chunk < lt->nchunks - 1) + nfc_op.ndcb[0] |= NDCB0_CMD_XTYPE(XTYPE_NAKED_RW); else nfc_op.ndcb[0] |= NDCB0_CMD_XTYPE(XTYPE_LAST_NAKED_RW);