after
commit 27d13da8782a ("w1: omap-hdq: Simplify driver with PM runtime autosuspend")
was applied, we did see timeouts and wrong values when reading a bq27000 connected to hdq of the omap3. This occurred mainly after boot and sometimes settled down after several reads indicating ignored interrupts.
root@letux:~# time cat /sys/class/power_supply/bq27000-battery/uevent POWER_SUPPLY_NAME=bq27000-battery POWER_SUPPLY_STATUS=Discharging POWER_SUPPLY_PRESENT=1 POWER_SUPPLY_VOLTAGE_NOW=0 POWER_SUPPLY_CURRENT_NOW=0 POWER_SUPPLY_CAPACITY=0 POWER_SUPPLY_CAPACITY_LEVEL=Normal POWER_SUPPLY_TEMP=-2731 POWER_SUPPLY_TIME_TO_EMPTY_NOW=0 POWER_SUPPLY_TIME_TO_EMPTY_AVG=0 POWER_SUPPLY_TIME_TO_FULL_NOW=0 POWER_SUPPLY_TECHNOLOGY=Li-ion POWER_SUPPLY_CHARGE_FULL=0 POWER_SUPPLY_CHARGE_NOW=0 POWER_SUPPLY_CHARGE_FULL_DESIGN=0 POWER_SUPPLY_CYCLE_COUNT=0 POWER_SUPPLY_ENERGY_NOW=0 POWER_SUPPLY_POWER_AVG=0 POWER_SUPPLY_HEALTH=Good POWER_SUPPLY_MANUFACTURER=Texas Instruments
real 0m15.761s user 0m0.001s sys 0m0.025s root@letux:~#
Sometimes the effect did disappear after trying multiple times and speed went up and results became correct.
Enabling debugging revealed that there were tx and rx timeouts, i.e. the driver does not always respond properly to interrupts.
This patch improves interrupt handling to avoid races and loss of interrupt flags.
The ideas are: * only the hdq_isr() sets bits in hdq_status * and does wake_up() * bits are only reset by the read/write/break functions if they were waited for * rx/tx/timeout bits are completely decoupled from each other (and not reset all after waiting for one of them) * which bits to reset is specified by a new parameter to hdq_reset_irqstatus() * hdq_reset_irqstatus() also returns the state before resetting so that we can encapsulate the spinlock * this should now handle the case that the write and read are both already finished quickly before the hdq_write_byte() ends. Old code may have reset all status bits making the next hdq_read_byte() timeout * the spinlock protects the reset of bits in function hdq_reset_irqstatus() which could be a read-write-modify problem if the interrupt handler tries to read-modify-write exactly at the same moment * add mutex protection also for hdq_write_byte() just to be safe not to disturb a hdq_read_byte() triggered by some other thread/process.
This patch was tested on a gta04 and results in
root@letux:~# time cat /sys/class/power_supply/bq27000-battery/uevent POWER_SUPPLY_NAME=bq27000-battery POWER_SUPPLY_STATUS=Discharging POWER_SUPPLY_PRESENT=1 POWER_SUPPLY_VOLTAGE_NOW=3970000 POWER_SUPPLY_CURRENT_NOW=354144 POWER_SUPPLY_CAPACITY=82 POWER_SUPPLY_CAPACITY_LEVEL=Normal POWER_SUPPLY_TEMP=266 POWER_SUPPLY_TIME_TO_EMPTY_NOW=7680 POWER_SUPPLY_TIME_TO_EMPTY_AVG=7380 POWER_SUPPLY_TECHNOLOGY=Li-ion POWER_SUPPLY_CHARGE_FULL=934856 POWER_SUPPLY_CHARGE_NOW=763976 POWER_SUPPLY_CHARGE_FULL_DESIGN=1233792 POWER_SUPPLY_CYCLE_COUNT=82 POWER_SUPPLY_ENERGY_NOW=2852840 POWER_SUPPLY_POWER_AVG=1392840 POWER_SUPPLY_HEALTH=Good POWER_SUPPLY_MANUFACTURER=Texas Instruments
real 0m0.233s user 0m0.000s sys 0m0.025s root@letux:~#
It was also tested with dev_dbg enabled and more printk that all activities behave correctly, especially hdq_write_byte(), hdq_read_byte(), omap_hdq_break().
Not tested is omap_w1_triplet().
Fixes: 27d13da8782a ("w1: omap-hdq: Simplify driver with PM runtime autosuspend") Cc: stable@vger.kernel.org # v5.6+ Signed-off-by: H. Nikolaus Schaller hns@goldelico.com --- drivers/w1/masters/omap_hdq.c | 56 ++++++++++++++++++++++++----------- 1 file changed, 38 insertions(+), 18 deletions(-)
diff --git a/drivers/w1/masters/omap_hdq.c b/drivers/w1/masters/omap_hdq.c index d363e2a89fdfc..384dad0615a26 100644 --- a/drivers/w1/masters/omap_hdq.c +++ b/drivers/w1/masters/omap_hdq.c @@ -54,10 +54,10 @@ MODULE_PARM_DESC(w1_id, "1-wire id for the slave detection in HDQ mode"); struct hdq_data { struct device *dev; void __iomem *hdq_base; - /* lock status update */ + /* lock read/write/status update */ struct mutex hdq_mutex; + /* interrupt status and lock */ u8 hdq_irqstatus; - /* device lock */ spinlock_t hdq_spinlock; /* mode: 0-HDQ 1-W1 */ int mode; @@ -120,13 +120,18 @@ static int hdq_wait_for_flag(struct hdq_data *hdq_data, u32 offset, }
/* Clear saved irqstatus after using an interrupt */ -static void hdq_reset_irqstatus(struct hdq_data *hdq_data) +static u8 hdq_reset_irqstatus(struct hdq_data *hdq_data, u8 bits) { unsigned long irqflags; + u8 status;
spin_lock_irqsave(&hdq_data->hdq_spinlock, irqflags); - hdq_data->hdq_irqstatus = 0; + status = hdq_data->hdq_irqstatus; + /* this is a read-modify-write */ + hdq_data->hdq_irqstatus &= ~bits; spin_unlock_irqrestore(&hdq_data->hdq_spinlock, irqflags); + + return status; }
/* write out a byte and fill *status with HDQ_INT_STATUS */ @@ -135,6 +140,12 @@ static int hdq_write_byte(struct hdq_data *hdq_data, u8 val, u8 *status) int ret; u8 tmp_status;
+ ret = mutex_lock_interruptible(&hdq_data->hdq_mutex); + if (ret < 0) { + ret = -EINTR; + goto rtn; + } + *status = 0;
hdq_reg_out(hdq_data, OMAP_HDQ_TX_DATA, val); @@ -144,14 +155,15 @@ static int hdq_write_byte(struct hdq_data *hdq_data, u8 val, u8 *status) OMAP_HDQ_CTRL_STATUS_DIR | OMAP_HDQ_CTRL_STATUS_GO); /* wait for the TXCOMPLETE bit */ ret = wait_event_timeout(hdq_wait_queue, - hdq_data->hdq_irqstatus, OMAP_HDQ_TIMEOUT); + (hdq_data->hdq_irqstatus & OMAP_HDQ_INT_STATUS_TXCOMPLETE), + OMAP_HDQ_TIMEOUT); + *status = hdq_reset_irqstatus(hdq_data, OMAP_HDQ_INT_STATUS_TXCOMPLETE); if (ret == 0) { dev_dbg(hdq_data->dev, "TX wait elapsed\n"); ret = -ETIMEDOUT; goto out; }
- *status = hdq_data->hdq_irqstatus; /* check irqstatus */ if (!(*status & OMAP_HDQ_INT_STATUS_TXCOMPLETE)) { dev_dbg(hdq_data->dev, "timeout waiting for" @@ -170,7 +182,8 @@ static int hdq_write_byte(struct hdq_data *hdq_data, u8 val, u8 *status) }
out: - hdq_reset_irqstatus(hdq_data); + mutex_unlock(&hdq_data->hdq_mutex); +rtn: return ret; }
@@ -181,7 +194,7 @@ static irqreturn_t hdq_isr(int irq, void *_hdq) unsigned long irqflags;
spin_lock_irqsave(&hdq_data->hdq_spinlock, irqflags); - hdq_data->hdq_irqstatus = hdq_reg_in(hdq_data, OMAP_HDQ_INT_STATUS); + hdq_data->hdq_irqstatus |= hdq_reg_in(hdq_data, OMAP_HDQ_INT_STATUS); spin_unlock_irqrestore(&hdq_data->hdq_spinlock, irqflags); dev_dbg(hdq_data->dev, "hdq_isr: %x\n", hdq_data->hdq_irqstatus);
@@ -238,14 +251,15 @@ static int omap_hdq_break(struct hdq_data *hdq_data)
/* wait for the TIMEOUT bit */ ret = wait_event_timeout(hdq_wait_queue, - hdq_data->hdq_irqstatus, OMAP_HDQ_TIMEOUT); + (hdq_data->hdq_irqstatus & OMAP_HDQ_INT_STATUS_TIMEOUT), + OMAP_HDQ_TIMEOUT); + tmp_status = hdq_reset_irqstatus(hdq_data, OMAP_HDQ_INT_STATUS_TIMEOUT); if (ret == 0) { dev_dbg(hdq_data->dev, "break wait elapsed\n"); ret = -EINTR; goto out; }
- tmp_status = hdq_data->hdq_irqstatus; /* check irqstatus */ if (!(tmp_status & OMAP_HDQ_INT_STATUS_TIMEOUT)) { dev_dbg(hdq_data->dev, "timeout waiting for TIMEOUT, %x\n", @@ -278,7 +292,6 @@ static int omap_hdq_break(struct hdq_data *hdq_data) " return to zero, %x\n", tmp_status);
out: - hdq_reset_irqstatus(hdq_data); mutex_unlock(&hdq_data->hdq_mutex); rtn: return ret; @@ -311,10 +324,11 @@ static int hdq_read_byte(struct hdq_data *hdq_data, u8 *val) (hdq_data->hdq_irqstatus & OMAP_HDQ_INT_STATUS_RXCOMPLETE), OMAP_HDQ_TIMEOUT); - + status = hdq_reset_irqstatus(hdq_data, + OMAP_HDQ_INT_STATUS_RXCOMPLETE); hdq_reg_merge(hdq_data, OMAP_HDQ_CTRL_STATUS, 0, OMAP_HDQ_CTRL_STATUS_DIR); - status = hdq_data->hdq_irqstatus; + /* check irqstatus */ if (!(status & OMAP_HDQ_INT_STATUS_RXCOMPLETE)) { dev_dbg(hdq_data->dev, "timeout waiting for" @@ -322,11 +336,12 @@ static int hdq_read_byte(struct hdq_data *hdq_data, u8 *val) ret = -ETIMEDOUT; goto out; } + } else { /* interrupt had occurred before hdq_read_byte was called */ + hdq_reset_irqstatus(hdq_data, OMAP_HDQ_INT_STATUS_RXCOMPLETE); } /* the data is ready. Read it in! */ *val = hdq_reg_in(hdq_data, OMAP_HDQ_RX_DATA); out: - hdq_reset_irqstatus(hdq_data); mutex_unlock(&hdq_data->hdq_mutex); rtn: return ret; @@ -367,15 +382,15 @@ static u8 omap_w1_triplet(void *_hdq, u8 bdir) (hdq_data->hdq_irqstatus & OMAP_HDQ_INT_STATUS_RXCOMPLETE), OMAP_HDQ_TIMEOUT); + /* Must clear irqstatus for another RXCOMPLETE interrupt */ + hdq_reset_irqstatus(hdq_data, OMAP_HDQ_INT_STATUS_RXCOMPLETE); + if (err == 0) { dev_dbg(hdq_data->dev, "RX wait elapsed\n"); goto out; } id_bit = (hdq_reg_in(_hdq, OMAP_HDQ_RX_DATA) & 0x01);
- /* Must clear irqstatus for another RXCOMPLETE interrupt */ - hdq_reset_irqstatus(hdq_data); - /* read comp_bit */ hdq_reg_merge(_hdq, OMAP_HDQ_CTRL_STATUS, ctrl | OMAP_HDQ_CTRL_STATUS_DIR, mask); @@ -383,6 +398,9 @@ static u8 omap_w1_triplet(void *_hdq, u8 bdir) (hdq_data->hdq_irqstatus & OMAP_HDQ_INT_STATUS_RXCOMPLETE), OMAP_HDQ_TIMEOUT); + /* Must clear irqstatus for another RXCOMPLETE interrupt */ + hdq_reset_irqstatus(hdq_data, OMAP_HDQ_INT_STATUS_RXCOMPLETE); + if (err == 0) { dev_dbg(hdq_data->dev, "RX wait elapsed\n"); goto out; @@ -409,6 +427,9 @@ static u8 omap_w1_triplet(void *_hdq, u8 bdir) (hdq_data->hdq_irqstatus & OMAP_HDQ_INT_STATUS_TXCOMPLETE), OMAP_HDQ_TIMEOUT); + /* Must clear irqstatus for another TXCOMPLETE interrupt */ + hdq_reset_irqstatus(hdq_data, OMAP_HDQ_INT_STATUS_TXCOMPLETE); + if (err == 0) { dev_dbg(hdq_data->dev, "TX wait elapsed\n"); goto out; @@ -418,7 +439,6 @@ static u8 omap_w1_triplet(void *_hdq, u8 bdir) OMAP_HDQ_CTRL_STATUS_SINGLE);
out: - hdq_reset_irqstatus(hdq_data); mutex_unlock(&hdq_data->hdq_mutex); rtn: pm_runtime_mark_last_busy(hdq_data->dev);
linux-stable-mirror@lists.linaro.org