In case this PHY is bootstrapped for managed mode, we need to manually wake it. Otherwise no link will be detected.
Cc: stable@vger.kernel.org Fixes: cb80ee2f9bee1 ("net: phy: Add support for the DP83TG720S Ethernet PHY") Signed-off-by: Oleksij Rempel o.rempel@pengutronix.de --- drivers/net/phy/dp83tg720.c | 18 +++++++++++++++--- 1 file changed, 15 insertions(+), 3 deletions(-)
diff --git a/drivers/net/phy/dp83tg720.c b/drivers/net/phy/dp83tg720.c index 326c9770a6dcc..1186dfc70fb3c 100644 --- a/drivers/net/phy/dp83tg720.c +++ b/drivers/net/phy/dp83tg720.c @@ -17,6 +17,11 @@ #define DP83TG720S_PHY_RESET 0x1f #define DP83TG720S_HW_RESET BIT(15)
+#define DP83TG720S_LPS_CFG3 0x18c +/* Power modes are documented as bit fields but used as values */ +/* Power Mode 0 is Normal mode */ +#define DP83TG720S_LPS_CFG3_PWR_MODE_0 BIT(0) + #define DP83TG720S_RGMII_DELAY_CTRL 0x602 /* In RGMII mode, Enable or disable the internal delay for RXD */ #define DP83TG720S_RGMII_RX_CLK_SEL BIT(1) @@ -154,10 +159,17 @@ static int dp83tg720_config_init(struct phy_device *phydev) */ usleep_range(1000, 2000);
- if (phy_interface_is_rgmii(phydev)) - return dp83tg720_config_rgmii_delay(phydev); + if (phy_interface_is_rgmii(phydev)) { + ret = dp83tg720_config_rgmii_delay(phydev); + if (ret) + return ret; + }
- return 0; + /* In case the PHY is bootstrapped in managed mode, we need to + * wake it. + */ + return phy_write_mmd(phydev, MDIO_MMD_VEND2, DP83TG720S_LPS_CFG3, + DP83TG720S_LPS_CFG3_PWR_MODE_0); }
static struct phy_driver dp83tg720_driver[] = {
Get master/slave configuration for initial system start with the link in down state. This ensures ethtool shows current configuration. Also fixes link reconfiguration with ethtool while in down state, preventing ethtool from displaying outdated configuration.
Even though dp83tg720_config_init() is executed periodically as long as the link is in admin up state but no carrier is detected, this is not sufficient for the link in admin down state where dp83tg720_read_status() is not periodically executed. To cover this case, we need an extra read role configuration in dp83tg720_config_aneg().
Fixes: cb80ee2f9bee1 ("net: phy: Add support for the DP83TG720S Ethernet PHY") Cc: stable@vger.kernel.org Signed-off-by: Oleksij Rempel o.rempel@pengutronix.de --- changes v2: - add genphy_c45_pma_baset1_read_master_slave() to .config_aneg - add comments --- drivers/net/phy/dp83tg720.c | 24 +++++++++++++++++++++--- 1 file changed, 21 insertions(+), 3 deletions(-)
diff --git a/drivers/net/phy/dp83tg720.c b/drivers/net/phy/dp83tg720.c index 1186dfc70fb3c..c706429b225a2 100644 --- a/drivers/net/phy/dp83tg720.c +++ b/drivers/net/phy/dp83tg720.c @@ -36,11 +36,20 @@
static int dp83tg720_config_aneg(struct phy_device *phydev) { + int ret; + /* Autoneg is not supported and this PHY supports only one speed. * We need to care only about master/slave configuration if it was * changed by user. */ - return genphy_c45_pma_baset1_setup_master_slave(phydev); + ret = genphy_c45_pma_baset1_setup_master_slave(phydev); + if (ret) + return ret; + + /* Re-read role configuration to make changes visible even if + * the link is in administrative down state. + */ + return genphy_c45_pma_baset1_read_master_slave(phydev); }
static int dp83tg720_read_status(struct phy_device *phydev) @@ -69,6 +78,8 @@ static int dp83tg720_read_status(struct phy_device *phydev) return ret;
/* After HW reset we need to restore master/slave configuration. + * genphy_c45_pma_baset1_read_master_slave() call will be done + * by the dp83tg720_config_aneg() function. */ ret = dp83tg720_config_aneg(phydev); if (ret) @@ -168,8 +179,15 @@ static int dp83tg720_config_init(struct phy_device *phydev) /* In case the PHY is bootstrapped in managed mode, we need to * wake it. */ - return phy_write_mmd(phydev, MDIO_MMD_VEND2, DP83TG720S_LPS_CFG3, - DP83TG720S_LPS_CFG3_PWR_MODE_0); + ret = phy_write_mmd(phydev, MDIO_MMD_VEND2, DP83TG720S_LPS_CFG3, + DP83TG720S_LPS_CFG3_PWR_MODE_0); + if (ret) + return ret; + + /* Make role configuration visible for ethtool on init and after + * rest. + */ + return genphy_c45_pma_baset1_read_master_slave(phydev); }
static struct phy_driver dp83tg720_driver[] = {
Hello:
This series was applied to netdev/net.git (main) by Jakub Kicinski kuba@kernel.org:
On Fri, 14 Jun 2024 11:45:15 +0200 you wrote:
In case this PHY is bootstrapped for managed mode, we need to manually wake it. Otherwise no link will be detected.
Cc: stable@vger.kernel.org Fixes: cb80ee2f9bee1 ("net: phy: Add support for the DP83TG720S Ethernet PHY") Signed-off-by: Oleksij Rempel o.rempel@pengutronix.de
[...]
Here is the summary with links: - [net,v2,1/2] net: phy: dp83tg720: wake up PHYs in managed mode https://git.kernel.org/netdev/net/c/cd6f12e173df - [net,v2,2/2] net: phy: dp83tg720: get master/slave configuration in link down state https://git.kernel.org/netdev/net/c/40a64cc96795
You are awesome, thank you!
linux-stable-mirror@lists.linaro.org
-
Oleksij Rempel -
patchwork-bot+netdevbpf＠kernel.org