From: Stefan Eichenberger stefan.eichenberger@toradex.com

The current solution for powering off the Apalis iMX6 is not functioning as intended. To resolve this, it is necessary to power off the vgen2_reg, which will also set the POWER_ENABLE_MOCI signal to a low state. This ensures the carrier board is properly informed to initiate its power-off sequence.

The new solution uses the regulator-poweroff driver, which will power off the regulator during a system shutdown.

CC: stable@vger.kernel.org Fixes: 4eb56e26f92e ("ARM: dts: imx6q-apalis: Command pmic to standby for poweroff") Signed-off-by: Stefan Eichenberger stefan.eichenberger@toradex.com --- arch/arm/boot/dts/nxp/imx/imx6qdl-apalis.dtsi | 10 +++++----- 1 file changed, 5 insertions(+), 5 deletions(-)

diff --git a/arch/arm/boot/dts/nxp/imx/imx6qdl-apalis.dtsi b/arch/arm/boot/dts/nxp/imx/imx6qdl-apalis.dtsi index 1c72da417011..614b65821995 100644 --- a/arch/arm/boot/dts/nxp/imx/imx6qdl-apalis.dtsi +++ b/arch/arm/boot/dts/nxp/imx/imx6qdl-apalis.dtsi @@ -108,6 +108,11 @@ lvds_panel_in: endpoint { }; };

+ poweroff { + compatible = "regulator-poweroff"; + cpu-supply = <&vgen2_reg>; + }; + reg_module_3v3: regulator-module-3v3 { compatible = "regulator-fixed"; regulator-always-on; @@ -236,10 +241,6 @@ &can2 { status = "disabled"; };

-&clks { - fsl,pmic-stby-poweroff; -}; - /* Apalis SPI1 */ &ecspi1 { cs-gpios = <&gpio5 25 GPIO_ACTIVE_LOW>; @@ -527,7 +528,6 @@ &i2c2 {

pmic: pmic@8 { compatible = "fsl,pfuze100"; - fsl,pmic-stby-poweroff; reg = <0x08>;

regulators {