On Thu, Jun 19, 2025 at 9:13 AM Zhang Rui rui.zhang@intel.com wrote:

PL1 cannot be disabled on some platforms. The ENABLE bit is still set after software clears it. This behavior leads to a scenario where, upon user request to disable the Power Limit through the powercap sysfs, the ENABLE bit remains set while the CLAMPING bit is inadvertently cleared.

According to the Intel Software Developer's Manual, the CLAMPING bit, "When set, allows the processor to go below the OS requested P states in order to maintain the power below specified Platform Power Limit value."

Thus this means the system may operate at higher power levels than intended on such platforms.

Enhance the code to check ENABLE bit after writing to it, and stop further processing if ENABLE bit cannot be changed.

Cc: stable@vger.kernel.org Reported-by: Srinivas Pandruvada srinivas.pandruvada@linux.intel.com Fixes: 2d281d8196e3 ("PowerCap: Introduce Intel RAPL power capping driver") Signed-off-by: Zhang Rui rui.zhang@intel.com

---

Changes since V1:

• Add Fixes tag
• CC stable kernel

---

drivers/powercap/intel_rapl_common.c | 17 ++++++++++++++++- 1 file changed, 16 insertions(+), 1 deletion(-)

diff --git a/drivers/powercap/intel_rapl_common.c b/drivers/powercap/intel_rapl_common.c index e3be40adc0d7..602f540cbe15 100644 --- a/drivers/powercap/intel_rapl_common.c +++ b/drivers/powercap/intel_rapl_common.c @@ -341,12 +341,27 @@ static int set_domain_enable(struct powercap_zone *power_zone, bool mode) { struct rapl_domain *rd = power_zone_to_rapl_domain(power_zone); struct rapl_defaults *defaults = get_defaults(rd->rp);

•   u64 val;
    int ret;
  
    cpus_read_lock();
    ret = rapl_write_pl_data(rd, POWER_LIMIT1, PL_ENABLE, mode);
  

•   if (!ret && defaults->set_floor_freq)
  

•   if (ret)
  

•           goto end;
  

•   ret = rapl_read_pl_data(rd, POWER_LIMIT1, PL_ENABLE, false, &val);
  

•   if (ret)
  

•           goto end;
  

•   if (mode != val) {
  

•           pr_debug("%s cannot be %s\n", power_zone->name, mode ? "enabled" : "disabled");
  

•           goto end;
  

•   }
  

•   if (defaults->set_floor_freq)
            defaults->set_floor_freq(rd, mode);
  

+end: cpus_read_unlock();

    return ret;

--

Applied as 6.16-rc material, thanks!