SFLASHC_BURST_CFG is only available on older ipq nand platforms, this register has been removed when the NAND controller is moved as part of qpic controller.

avoid register writes to this register on devices which are based on qpic NAND controllers.

Fixes: a0637834 (mtd: nand: qcom: support for IPQ4019 QPIC NANDcontroller) Fixes: dce84760 (mtd: nand: qcom: Support for IPQ8074 QPIC NAND controller) Cc: stable@vger.kernel.org Signed-off-by: Sivaprakash Murugesan sivaprak@codeaurora.org --- [V3] * Addressed Miquel comments, added flag based on nand controller hw to avoid the register writes to specific ipq platforms drivers/mtd/nand/raw/qcom_nandc.c | 8 +++++++- 1 file changed, 7 insertions(+), 1 deletion(-)

diff --git a/drivers/mtd/nand/raw/qcom_nandc.c b/drivers/mtd/nand/raw/qcom_nandc.c index f1daf33..e0c55bb 100644 --- a/drivers/mtd/nand/raw/qcom_nandc.c +++ b/drivers/mtd/nand/raw/qcom_nandc.c @@ -459,11 +459,13 @@ struct qcom_nand_host { * among different NAND controllers. * @ecc_modes - ecc mode for NAND * @is_bam - whether NAND controller is using BAM + * @is_qpic - whether NAND CTRL is part of qpic IP * @dev_cmd_reg_start - NAND_DEV_CMD_* registers starting offset */ struct qcom_nandc_props { u32 ecc_modes; bool is_bam; + bool is_qpic; u32 dev_cmd_reg_start; };

@@ -2774,7 +2776,8 @@ static int qcom_nandc_setup(struct qcom_nand_controller *nandc) u32 nand_ctrl;

/* kill onenand */ - nandc_write(nandc, SFLASHC_BURST_CFG, 0); + if (!nandc->props->is_qpic) + nandc_write(nandc, SFLASHC_BURST_CFG, 0); nandc_write(nandc, dev_cmd_reg_addr(nandc, NAND_DEV_CMD_VLD), NAND_DEV_CMD_VLD_VAL);

@@ -3029,18 +3032,21 @@ static int qcom_nandc_remove(struct platform_device *pdev) static const struct qcom_nandc_props ipq806x_nandc_props = { .ecc_modes = (ECC_RS_4BIT | ECC_BCH_8BIT), .is_bam = false, + .is_qpic = false, .dev_cmd_reg_start = 0x0, };

static const struct qcom_nandc_props ipq4019_nandc_props = { .ecc_modes = (ECC_BCH_4BIT | ECC_BCH_8BIT), .is_bam = true, + .is_qpic = true, .dev_cmd_reg_start = 0x0, };

static const struct qcom_nandc_props ipq8074_nandc_props = { .ecc_modes = (ECC_BCH_4BIT | ECC_BCH_8BIT), .is_bam = true, + .is_qpic = true, .dev_cmd_reg_start = 0x7000, };