The patch below does not apply to the 5.10-stable tree. If someone wants it applied there, or to any other stable or longterm tree, then please email the backport, including the original git commit id to stable@vger.kernel.org.

thanks,

greg k-h

------------------ original commit in Linus's tree ------------------

From e16eceea863b417fd328588b1be1a79de0bc937f Mon Sep 17 00:00:00 2001 From: Olga Kitaina okitain@gmail.com Date: Tue, 28 Jun 2022 21:18:24 +0530 Subject: [PATCH] mtd: rawnand: arasan: Fix clock rate in NV-DDR

According to the Arasan NAND controller spec, the flash clock rate for SDR must be <= 100 MHz, while for NV-DDR it must be the same as the rate of the CLK line for the mode. The driver previously always set 100 MHz for NV-DDR, which would result in incorrect behavior for NV-DDR modes 0-4.

The appropriate clock rate can be calculated from the NV-DDR timing parameters as 1/tCK, or for rates measured in picoseconds, 10^12 / nand_nvddr_timings->tCK_min.

Fixes: 197b88fecc50 ("mtd: rawnand: arasan: Add new Arasan NAND controller") CC: stable@vger.kernel.org # 5.8+ Signed-off-by: Olga Kitaina okitain@gmail.com Signed-off-by: Amit Kumar Mahapatra amit.kumar-mahapatra@xilinx.com Signed-off-by: Miquel Raynal miquel.raynal@bootlin.com Link: https://lore.kernel.org/linux-mtd/20220628154824.12222-3-amit.kumar-mahapatr...

diff --git a/drivers/mtd/nand/raw/arasan-nand-controller.c b/drivers/mtd/nand/raw/arasan-nand-controller.c index c5264fa223c4..296fb16c8dc3 100644 --- a/drivers/mtd/nand/raw/arasan-nand-controller.c +++ b/drivers/mtd/nand/raw/arasan-nand-controller.c @@ -1043,7 +1043,13 @@ static int anfc_setup_interface(struct nand_chip *chip, int target, DQS_BUFF_SEL_OUT(dqs_mode); }

- anand->clk = ANFC_XLNX_SDR_DFLT_CORE_CLK; + if (nand_interface_is_sdr(conf)) { + anand->clk = ANFC_XLNX_SDR_DFLT_CORE_CLK; + } else { + /* ONFI timings are defined in picoseconds */ + anand->clk = div_u64((u64)NSEC_PER_SEC * 1000, + conf->timings.nvddr.tCK_min); + }

/* * Due to a hardware bug in the ZynqMP SoC, SDR timing modes 0-1 work