Commit 3f66425a4fc8 ("cpufreq: Enable COMPILE_TEST on Arm drivers") enabled compile testing of most Arm CPUFreq drivers but left the existing default values unchanged so that many drivers are enabled by default whenever COMPILE_TEST is selected.

This specifically results in the S3C64XX CPUFreq driver being enabled and initialised during boot of non-S3C64XX platforms with the following error logged:

cpufreq: Unable to obtain ARMCLK: -2

Commit d4f610a9bafd ("cpufreq: Do not enable by default during compile testing") recently fixed most of the default values, but two entries were missed and two could use a more specific default condition.

Fix the default values for drivers that can be compile tested and that should be enabled by default when not compile testing.

Fixes: 3f66425a4fc8 ("cpufreq: Enable COMPILE_TEST on Arm drivers") Cc: stable@vger.kernel.org # 6.12: d4f610a9bafd Cc: Rob Herring (Arm) robh@kernel.org Signed-off-by: Johan Hovold johan+linaro@kernel.org ---

Changes in v3: - use stable backport dependency notation instead of a Fixes tag for the partial fix

Changes in v2: - rebase on commit d4f610a9bafd ("cpufreq: Do not enable by default during compile testing")

drivers/cpufreq/Kconfig.arm | 8 ++++---- 1 file changed, 4 insertions(+), 4 deletions(-)

diff --git a/drivers/cpufreq/Kconfig.arm b/drivers/cpufreq/Kconfig.arm index d4d625ded285..0d46402e3094 100644 --- a/drivers/cpufreq/Kconfig.arm +++ b/drivers/cpufreq/Kconfig.arm @@ -76,7 +76,7 @@ config ARM_VEXPRESS_SPC_CPUFREQ config ARM_BRCMSTB_AVS_CPUFREQ tristate "Broadcom STB AVS CPUfreq driver" depends on (ARCH_BRCMSTB && !ARM_SCMI_CPUFREQ) || COMPILE_TEST - default ARCH_BRCMSTB + default y if ARCH_BRCMSTB && !ARM_SCMI_CPUFREQ help Some Broadcom STB SoCs use a co-processor running proprietary firmware ("AVS") to handle voltage and frequency scaling. This driver provides @@ -88,7 +88,7 @@ config ARM_HIGHBANK_CPUFREQ tristate "Calxeda Highbank-based" depends on ARCH_HIGHBANK || COMPILE_TEST depends on CPUFREQ_DT && REGULATOR && PL320_MBOX - default m + default m if ARCH_HIGHBANK help This adds the CPUFreq driver for Calxeda Highbank SoC based boards. @@ -133,7 +133,7 @@ config ARM_MEDIATEK_CPUFREQ config ARM_MEDIATEK_CPUFREQ_HW tristate "MediaTek CPUFreq HW driver" depends on ARCH_MEDIATEK || COMPILE_TEST - default m + default m if ARCH_MEDIATEK help Support for the CPUFreq HW driver. Some MediaTek chipsets have a HW engine to offload the steps @@ -256,7 +256,7 @@ config ARM_TEGRA194_CPUFREQ tristate "Tegra194 CPUFreq support" depends on ARCH_TEGRA_194_SOC || ARCH_TEGRA_234_SOC || (64BIT && COMPILE_TEST) depends on TEGRA_BPMP - default ARCH_TEGRA + default ARCH_TEGRA_194_SOC || ARCH_TEGRA_234_SOC help This adds CPU frequency driver support for Tegra194 SOCs.