From: Olga Kitaina okitain@gmail.com

According to the Arasan NAND controller spec, the flash clock rate for SDR must be <= 100 MHz, while for NV-DDR it must be the same as the rate of the CLK line for the mode. The driver previously always set 100 MHz for NV-DDR, which would result in incorrect behavior for NV-DDR modes 0-4.

The appropriate clock rate can be calculated from the NV-DDR timing parameters as 1/tCK, or for rates measured in picoseconds, 10^12 / nand_nvddr_timings->tCK_min.

Fixes: 197b88fecc50 ("mtd: rawnand: arasan: Add new Arasan NAND controller") CC: stable@vger.kernel.org # 5.8+ Signed-off-by: Olga Kitaina okitain@gmail.com Signed-off-by: Amit Kumar Mahapatra amit.kumar-mahapatra@xilinx.com --- drivers/mtd/nand/raw/arasan-nand-controller.c | 8 +++++++- 1 file changed, 7 insertions(+), 1 deletion(-)

diff --git a/drivers/mtd/nand/raw/arasan-nand-controller.c b/drivers/mtd/nand/raw/arasan-nand-controller.c index c5264fa223c4..d4121d1243bf 100644 --- a/drivers/mtd/nand/raw/arasan-nand-controller.c +++ b/drivers/mtd/nand/raw/arasan-nand-controller.c @@ -1043,7 +1043,13 @@ static int anfc_setup_interface(struct nand_chip *chip, int target, DQS_BUFF_SEL_OUT(dqs_mode); }

- anand->clk = ANFC_XLNX_SDR_DFLT_CORE_CLK; + if (nand_interface_is_sdr(conf)) { + anand->clk = ANFC_XLNX_SDR_DFLT_CORE_CLK; + } else { + /* ONFI timings are defined in picoseconds */ + anand->clk = div_u64((u64)NSEC_PER_SEC * 1000, + conf->timings.nvddr.tCK_min); + }

/* * Due to a hardware bug in the ZynqMP SoC, SDR timing modes 0-1 work