pm_runtime handles sdio power on and power off transitions. An old workaround for trying to control the power explicitly from the driver was in fact causing failures on suspend/resume as the mmc layer already power the module on resume.

In case of resume pm_runtime_get sync returns a positive device's usage count causing the driver to try an re-initialize an already initialized device. This was causing sdio bus failure on resume.

Remove this manual power on/off sequence as it is in-fact not needed.

Signed-off-by: Eyal Reizer eyalr@ti.com Cc: stable@vger.kernel.org --- drivers/net/wireless/ti/wlcore/sdio.c | 27 ++++++--------------------- 1 file changed, 6 insertions(+), 21 deletions(-)

diff --git a/drivers/net/wireless/ti/wlcore/sdio.c b/drivers/net/wireless/ti/wlcore/sdio.c index 1f727ba..6dbe61d 100644 --- a/drivers/net/wireless/ti/wlcore/sdio.c +++ b/drivers/net/wireless/ti/wlcore/sdio.c @@ -155,17 +155,11 @@ static int wl12xx_sdio_power_on(struct wl12xx_sdio_glue *glue) struct mmc_card *card = func->card;

ret = pm_runtime_get_sync(&card->dev); - if (ret) { - /* - * Runtime PM might be temporarily disabled, or the device - * might have a positive reference counter. Make sure it is - * really powered on. - */ - ret = mmc_power_restore_host(card->host); - if (ret < 0) { - pm_runtime_put_sync(&card->dev); - goto out; - } + if (ret < 0) { + pm_runtime_put_noidle(&card->dev); + dev_err(glue->dev, "%s: failed to get_sync(%d)\n", + __func__, ret); + goto out; }

sdio_claim_host(func); @@ -178,7 +172,6 @@ static int wl12xx_sdio_power_on(struct wl12xx_sdio_glue *glue)

static int wl12xx_sdio_power_off(struct wl12xx_sdio_glue *glue) { - int ret; struct sdio_func *func = dev_to_sdio_func(glue->dev); struct mmc_card *card = func->card;

@@ -186,16 +179,8 @@ static int wl12xx_sdio_power_off(struct wl12xx_sdio_glue *glue) sdio_disable_func(func); sdio_release_host(func);

- /* Power off the card manually in case it wasn't powered off above */ - ret = mmc_power_save_host(card->host); - if (ret < 0) - goto out; - /* Let runtime PM know the card is powered off */ - pm_runtime_put_sync(&card->dev); - -out: - return ret; + return pm_runtime_put_sync(&card->dev); }

static int wl12xx_sdio_set_power(struct device *child, bool enable)