From: Niklas Cassel cassel@kernel.org

[ Upstream commit 80dc18a0cba8dea42614f021b20a04354b213d86 ]

As per PCIe r6.0, sec 6.6.1, a Downstream Port that supports Link speeds greater than 5.0 GT/s, software must wait a minimum of 100 ms after Link training completes before sending a Configuration Request.

Add this delay in dw_pcie_wait_for_link(), after the link is reported as up. The delay will only be performed in the success case where the link came up.

DWC glue drivers that have a link up IRQ (drivers that set use_linkup_irq = true) do not call dw_pcie_wait_for_link(), instead they perform this delay in their threaded link up IRQ handler.

Signed-off-by: Niklas Cassel cassel@kernel.org Signed-off-by: Manivannan Sadhasivam mani@kernel.org Reviewed-by: Damien Le Moal dlemoal@kernel.org Reviewed-by: Wilfred Mallawa wilfred.mallawa@wdc.com Cc: stable@vger.kernel.org # 6.12.x --- drivers/pci/controller/dwc/pcie-designware.c | 8 ++++++++ 1 file changed, 8 insertions(+)

diff --git a/drivers/pci/controller/dwc/pcie-designware.c b/drivers/pci/controller/dwc/pcie-designware.c index d40afe74ddd1a..f9473b8160778 100644 --- a/drivers/pci/controller/dwc/pcie-designware.c +++ b/drivers/pci/controller/dwc/pcie-designware.c @@ -655,6 +655,14 @@ int dw_pcie_wait_for_link(struct dw_pcie *pci) return -ETIMEDOUT; }

+ /* + * As per PCIe r6.0, sec 6.6.1, a Downstream Port that supports Link + * speeds greater than 5.0 GT/s, software must wait a minimum of 100 ms + * after Link training completes before sending a Configuration Request. + */ + if (pci->max_link_speed > 2) + msleep(PCIE_RESET_CONFIG_WAIT_MS); + offset = dw_pcie_find_capability(pci, PCI_CAP_ID_EXP); val = dw_pcie_readw_dbi(pci, offset + PCI_EXP_LNKSTA);