Commit under Fixes added support for power regulators on the J721E SK board. However, while doing so, it incorrectly assigned a non-existent pinmux within the WKUP Pinmux region (pinctrl@4301c000) instead of using the MAIN Pinmux region (pinctrl@11c000). This leads to the following silent failure:

pinctrl-single 4301c000.pinctrl: mux offset out of range: 0x1dc (0x178)

The datasheet for the J721E SoC [0] specifies on page 142 that the pinmux of interest which is Ball Y1 is PADCONFIG119 and the address corresponding to it is 0x00011C1DC which belongs to the MAIN Pinmux region.

Hence, fix this.

[0]: https://www.ti.com/lit/ds/symlink/tda4vm.pdf Fixes: 97b67cc102dc ("arm64: dts: ti: k3-j721e-sk: Add DT nodes for power regulators") Cc: stable@vger.kernel.org Signed-off-by: Siddharth Vadapalli s-vadapalli@ti.com ---

Hello,

This patch is based on commit e7c375b18160 Merge tag 'vfs-6.18-rc7.fixes' of gitolite.kernel.org:pub/scm/linux/kernel/git/vfs/vfs of Mainline Linux.

Regards, Siddharth.

arch/arm64/boot/dts/ti/k3-j721e-sk.dts | 12 ++++++------ 1 file changed, 6 insertions(+), 6 deletions(-)

diff --git a/arch/arm64/boot/dts/ti/k3-j721e-sk.dts b/arch/arm64/boot/dts/ti/k3-j721e-sk.dts index 5e5784ef6f85..77dcc160eda3 100644 --- a/arch/arm64/boot/dts/ti/k3-j721e-sk.dts +++ b/arch/arm64/boot/dts/ti/k3-j721e-sk.dts @@ -474,6 +474,12 @@ rpi_header_gpio1_pins_default: rpi-header-gpio1-default-pins { J721E_IOPAD(0x234, PIN_INPUT, 7) /* (U3) EXT_REFCLK1.GPIO1_12 */ >; }; + + vdd_sd_dv_pins_default: vdd-sd-dv-default-pins { + pinctrl-single,pins = < + J721E_IOPAD(0x1dc, PIN_OUTPUT, 7) /* (Y1) SPI1_CLK.GPIO0_118 */ + >; + }; };

&wkup_pmx0 { @@ -536,12 +542,6 @@ J721E_WKUP_IOPAD(0xd4, PIN_OUTPUT, 7) /* (G26) WKUP_GPIO0_9 */ >; };

- vdd_sd_dv_pins_default: vdd-sd-dv-default-pins { - pinctrl-single,pins = < - J721E_IOPAD(0x1dc, PIN_OUTPUT, 7) /* (Y1) SPI1_CLK.GPIO0_118 */ - >; - }; - wkup_uart0_pins_default: wkup-uart0-default-pins { pinctrl-single,pins = < J721E_WKUP_IOPAD(0xa0, PIN_INPUT, 0) /* (J29) WKUP_UART0_RXD */