6.1-stable review patch. If anyone has any objections, please let me know.
------------------
From: Pavel Krasavin pkrasavin@imaqliq.com
commit 2a1d728f20edeee7f26dc307ed9df4e0d23947ab upstream.
There might be hard lockup if we set crtscts mode on port without RTS/CTS configured:
# stty -F /dev/ttyAML6 crtscts; echo 1 > /dev/ttyAML6; echo 2 > /dev/ttyAML6 [ 95.890386] rcu: INFO: rcu_preempt detected stalls on CPUs/tasks: [ 95.890857] rcu: 3-...0: (201 ticks this GP) idle=e33c/1/0x4000000000000000 softirq=5844/5846 fqs=4984 [ 95.900212] rcu: (detected by 2, t=21016 jiffies, g=7753, q=296 ncpus=4) [ 95.906972] Task dump for CPU 3: [ 95.910178] task:bash state:R running task stack:0 pid:205 ppid:1 flags:0x00000202 [ 95.920059] Call trace: [ 95.922485] __switch_to+0xe4/0x168 [ 95.925951] 0xffffff8003477508 [ 95.974379] watchdog: Watchdog detected hard LOCKUP on cpu 3 [ 95.974424] Modules linked in: 88x2cs(O) rtc_meson_vrtc
Possible solution would be to not allow to setup crtscts on such port.
Tested on S905X3 based board.
Fixes: ff7693d079e5 ("ARM: meson: serial: add MesonX SoC on-chip uart driver") Cc: stable@vger.kernel.org Signed-off-by: Pavel Krasavin pkrasavin@imaqliq.com Reviewed-by: Neil Armstrong neil.armstrong@linaro.org Reviewed-by: Dmitry Rokosov ddrokosov@salutedevices.com Signed-off-by: Greg Kroah-Hartman gregkh@linuxfoundation.org --- drivers/tty/serial/meson_uart.c | 14 +++++++++++--- 1 file changed, 11 insertions(+), 3 deletions(-)
--- a/drivers/tty/serial/meson_uart.c +++ b/drivers/tty/serial/meson_uart.c @@ -380,10 +380,14 @@ static void meson_uart_set_termios(struc else val |= AML_UART_STOP_BIT_1SB;
- if (cflags & CRTSCTS) - val &= ~AML_UART_TWO_WIRE_EN; - else + if (cflags & CRTSCTS) { + if (port->flags & UPF_HARD_FLOW) + val &= ~AML_UART_TWO_WIRE_EN; + else + termios->c_cflag &= ~CRTSCTS; + } else { val |= AML_UART_TWO_WIRE_EN; + }
writel(val, port->membase + AML_UART_CONTROL);
@@ -698,6 +702,7 @@ static int meson_uart_probe(struct platf u32 fifosize = 64; /* Default is 64, 128 for EE UART_0 */ int ret = 0; int irq; + bool has_rtscts;
if (pdev->dev.of_node) pdev->id = of_alias_get_id(pdev->dev.of_node, "serial"); @@ -725,6 +730,7 @@ static int meson_uart_probe(struct platf return irq;
of_property_read_u32(pdev->dev.of_node, "fifo-size", &fifosize); + has_rtscts = of_property_read_bool(pdev->dev.of_node, "uart-has-rtscts");
if (meson_ports[pdev->id]) { dev_err(&pdev->dev, "port %d already allocated\n", pdev->id); @@ -744,6 +750,8 @@ static int meson_uart_probe(struct platf port->mapsize = resource_size(res_mem); port->irq = irq; port->flags = UPF_BOOT_AUTOCONF | UPF_LOW_LATENCY; + if (has_rtscts) + port->flags |= UPF_HARD_FLOW; port->has_sysrq = IS_ENABLED(CONFIG_SERIAL_MESON_CONSOLE); port->dev = &pdev->dev; port->line = pdev->id;