6.7-stable review patch. If anyone has any objections, please let me know.
------------------
From: Lino Sanfilippo l.sanfilippo@kunbus.com
commit 0c2a5f471ce58bca8f8ab5fcb911aff91eaaa5eb upstream.
The UART supports an auto-RTS mode in which the RTS pin is automatically activated during transmission. So mark this mode as being supported even if RTS is not controlled by the driver but the UART.
Also the serial core expects now at least one of both modes rts-on-send or rts-after-send to be supported. This is since during sanitization unsupported flags are deleted from a RS485 configuration set by userspace. However if the configuration ends up with both flags unset, the core prints a warning since it considers such a configuration invalid (see uart_sanitize_serial_rs485()).
Cc: stable@vger.kernel.org Reviewed-by: Ilpo Järvinen ilpo.jarvinen@linux.intel.com Signed-off-by: Lino Sanfilippo l.sanfilippo@kunbus.com Link: https://lore.kernel.org/r/20240103061818.564-8-l.sanfilippo@kunbus.com Signed-off-by: Greg Kroah-Hartman gregkh@linuxfoundation.org --- drivers/tty/serial/8250/8250_exar.c | 5 +++-- 1 file changed, 3 insertions(+), 2 deletions(-)
--- a/drivers/tty/serial/8250/8250_exar.c +++ b/drivers/tty/serial/8250/8250_exar.c @@ -480,7 +480,7 @@ static int sealevel_rs485_config(struct }
static const struct serial_rs485 generic_rs485_supported = { - .flags = SER_RS485_ENABLED, + .flags = SER_RS485_ENABLED | SER_RS485_RTS_ON_SEND, };
static const struct exar8250_platform exar8250_default_platform = { @@ -524,7 +524,8 @@ static int iot2040_rs485_config(struct u }
static const struct serial_rs485 iot2040_rs485_supported = { - .flags = SER_RS485_ENABLED | SER_RS485_RX_DURING_TX | SER_RS485_TERMINATE_BUS, + .flags = SER_RS485_ENABLED | SER_RS485_RTS_ON_SEND | + SER_RS485_RX_DURING_TX | SER_RS485_TERMINATE_BUS, };
static const struct property_entry iot2040_gpio_properties[] = {