From: Voon Weifeng weifeng.voon@intel.com
[ Upstream commit 7241c5a697479c7d0c5a96595822cdab750d41ae ]
EEE should be only be enabled during stmmac_mac_link_up() when the link are up and being set up properly. set_eee should only do settings configuration and disabling the eee.
Without this fix, turning on EEE using ethtool will return "Operation not supported". This is due to the driver is in a dead loop waiting for eee to be advertised in the for eee to be activated but the driver will only configure the EEE advertisement after the eee is activated.
Ethtool should only return "Operation not supported" if there is no EEE capbility in the MAC controller.
Fixes: 8a7493e58ad6 ("net: stmmac: Fix a race in EEE enable callback") Signed-off-by: Voon Weifeng weifeng.voon@intel.com Acked-by: Mark Gross mgross@linux.intel.com Signed-off-by: David S. Miller davem@davemloft.net Signed-off-by: Sasha Levin sashal@kernel.org --- .../net/ethernet/stmicro/stmmac/stmmac_ethtool.c | 15 ++++----------- 1 file changed, 4 insertions(+), 11 deletions(-)
diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_ethtool.c b/drivers/net/ethernet/stmicro/stmmac/stmmac_ethtool.c index 8c71090081852..5105e1f724fb7 100644 --- a/drivers/net/ethernet/stmicro/stmmac/stmmac_ethtool.c +++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_ethtool.c @@ -677,23 +677,16 @@ static int stmmac_ethtool_op_set_eee(struct net_device *dev, struct stmmac_priv *priv = netdev_priv(dev); int ret;
- if (!edata->eee_enabled) { + if (!priv->dma_cap.eee) + return -EOPNOTSUPP; + + if (!edata->eee_enabled) stmmac_disable_eee_mode(priv); - } else { - /* We are asking for enabling the EEE but it is safe - * to verify all by invoking the eee_init function. - * In case of failure it will return an error. - */ - edata->eee_enabled = stmmac_eee_init(priv); - if (!edata->eee_enabled) - return -EOPNOTSUPP; - }
ret = phy_ethtool_set_eee(dev->phydev, edata); if (ret) return ret;
- priv->eee_enabled = edata->eee_enabled; priv->tx_lpi_timer = edata->tx_lpi_timer; return 0; }