[ Upstream commit 055e04830d4544c57f2a5192a26c9e25915c29c0 ]
It has turned out that the sdhci-omap controller requires the R1B response, for commands that has this response associated with them. So, converting from an R1B to an R1 response for a CMD6 for example, leads to problems with the HW busy detection support.
Fix this by informing the mmc core about the requirement, via setting the host cap, MMC_CAP_NEED_RSP_BUSY.
Reported-by: Naresh Kamboju naresh.kamboju@linaro.org Reported-by: Anders Roxell anders.roxell@linaro.org Reported-by: Faiz Abbas faiz_abbas@ti.com Cc: stable@vger.kernel.org Tested-by: Anders Roxell anders.roxell@linaro.org Tested-by: Faiz Abbas faiz_abbas@ti.com Signed-off-by: Ulf Hansson ulf.hansson@linaro.org --- drivers/mmc/host/sdhci-omap.c | 3 +++ 1 file changed, 3 insertions(+)
diff --git a/drivers/mmc/host/sdhci-omap.c b/drivers/mmc/host/sdhci-omap.c index e9793d8e83a0..05ade7a2dd24 100644 --- a/drivers/mmc/host/sdhci-omap.c +++ b/drivers/mmc/host/sdhci-omap.c @@ -1147,6 +1147,9 @@ static int sdhci_omap_probe(struct platform_device *pdev) host->mmc_host_ops.execute_tuning = sdhci_omap_execute_tuning; host->mmc_host_ops.enable_sdio_irq = sdhci_omap_enable_sdio_irq;
+ /* R1B responses is required to properly manage HW busy detection. */ + mmc->caps |= MMC_CAP_NEED_RSP_BUSY; + ret = sdhci_setup_host(host); if (ret) goto err_put_sync;