The expected on-wire format of an SMBus Block Write is
S Addr Wr [A] Comm [A] Count [A] Data [A] Data [A] ... [A] Data [A] P
Everything starting from the Count byte is provided by the I2C subsystem in the array data->block. But the driver was skipping the Count byte (data->block[0]) when sending it to the RTL93xx I2C controller.
Only the actual data could be seen on the wire:
S Addr Wr [A] Comm [A] Data [A] Data [A] ... [A] Data [A] P
This wire format is not SMBus Block Write compatible but matches the format of an I2C Block Write. Simply adding the count byte to the buffer for the I2C controller enough to fix the transmission.
This also affects read because the I2C controller must receive the count byte + $count * data bytes.
Cc: stable@vger.kernel.org Fixes: c366be720235 ("i2c: Add driver for the RTL9300 I2C controller") Signed-off-by: Sven Eckelmann sven@narfation.org --- drivers/i2c/busses/i2c-rtl9300.c | 6 +++--- 1 file changed, 3 insertions(+), 3 deletions(-)
diff --git a/drivers/i2c/busses/i2c-rtl9300.c b/drivers/i2c/busses/i2c-rtl9300.c index a10e5e6e00075fabb8906d56f09f5b9141fbc06e..4e0844d97607f64386a6d7a7c4086a81fdd89d6c 100644 --- a/drivers/i2c/busses/i2c-rtl9300.c +++ b/drivers/i2c/busses/i2c-rtl9300.c @@ -284,15 +284,15 @@ static int rtl9300_i2c_smbus_xfer(struct i2c_adapter *adap, u16 addr, unsigned s ret = rtl9300_i2c_reg_addr_set(i2c, command, 1); if (ret) goto out_unlock; - ret = rtl9300_i2c_config_xfer(i2c, chan, addr, data->block[0]); + ret = rtl9300_i2c_config_xfer(i2c, chan, addr, data->block[0] + 1); if (ret) goto out_unlock; if (read_write == I2C_SMBUS_WRITE) { - ret = rtl9300_i2c_write(i2c, &data->block[1], data->block[0]); + ret = rtl9300_i2c_write(i2c, &data->block[0], data->block[0] + 1); if (ret) goto out_unlock; } - len = data->block[0]; + len = data->block[0] + 1; break;
default: