From: "Ren� van Dorst" opensource@vdorst.com
[ Upstream commit 22259471b51925353bd7b16f864c79fdd76e425e ]
Andrew reported:
After a number of network port link up/down changes, sometimes the switch port gets stuck in a state where it thinks it is still transmitting packets but the cpu port is not actually transmitting anymore. In this state you will see a message on the console "mtk_soc_eth 1e100000.ethernet eth0: transmit timed out" and the Tx counter in ifconfig will be incrementing on virtual port, but not incrementing on cpu port.
The issue is that MAC TX/RX status has no impact on the link status or queue manager of the switch. So the queue manager just queues up packets of a disabled port and sends out pause frames when the queue is full.
Change the LINK bit to reflect the link status.
Fixes: b8f126a8d543 ("net-next: dsa: add dsa support for Mediatek MT7530 switch") Reported-by: Andrew Smith andrew.smith@digi.com Signed-off-by: René van Dorst opensource@vdorst.com Reviewed-by: Vivien Didelot vivien.didelot@gmail.com Reviewed-by: Florian Fainelli f.fainelli@gmail.com Signed-off-by: David S. Miller davem@davemloft.net Signed-off-by: Greg Kroah-Hartman gregkh@linuxfoundation.org --- drivers/net/dsa/mt7530.c | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-)
--- a/drivers/net/dsa/mt7530.c +++ b/drivers/net/dsa/mt7530.c @@ -549,7 +549,7 @@ mt7530_mib_reset(struct dsa_switch *ds) static void mt7530_port_set_status(struct mt7530_priv *priv, int port, int enable) { - u32 mask = PMCR_TX_EN | PMCR_RX_EN; + u32 mask = PMCR_TX_EN | PMCR_RX_EN | PMCR_FORCE_LNK;
if (enable) mt7530_set(priv, MT7530_PMCR_P(port), mask);