From: Xu Yang xu.yang_2@nxp.com
[ Upstream commit dda4b60ed70bd670eefda081f70c0cb20bbeb1fa ]
Some NXP processor using chipidea IP has a bug when frame babble is detected.
As per 4.15.1.1.1 Serial Bus Babble: A babble condition also exists if IN transaction is in progress at High-speed SOF2 point. This is called frame babble. The host controller must disable the port to which the frame babble is detected.
The USB controller has disabled the port (PE cleared) and has asserted USBERRINT when frame babble is detected, but PEC is not asserted. Therefore, the SW isn't aware that port has been disabled. Then the SW keeps sending packets to this port, but all of the transfers will fail.
This workaround will firstly assert PCD by SW when USBERRINT is detected and then judge whether port change has really occurred or not by polling roothub status. Because the PEC doesn't get asserted in our case, this patch will also assert it by SW when specific conditions are satisfied.
Signed-off-by: Xu Yang xu.yang_2@nxp.com Acked-by: Peter Chen peter.chen@kernel.org Link: https://lore.kernel.org/r/20230809024432.535160-1-xu.yang_2@nxp.com Signed-off-by: Greg Kroah-Hartman gregkh@linuxfoundation.org Signed-off-by: Sasha Levin sashal@kernel.org --- drivers/usb/host/ehci-hcd.c | 8 ++++++-- drivers/usb/host/ehci-hub.c | 10 +++++++++- drivers/usb/host/ehci.h | 10 ++++++++++ 3 files changed, 25 insertions(+), 3 deletions(-)
diff --git a/drivers/usb/host/ehci-hcd.c b/drivers/usb/host/ehci-hcd.c index 1440803216297..02044d45edded 100644 --- a/drivers/usb/host/ehci-hcd.c +++ b/drivers/usb/host/ehci-hcd.c @@ -755,10 +755,14 @@ static irqreturn_t ehci_irq (struct usb_hcd *hcd)
/* normal [4.15.1.2] or error [4.15.1.1] completion */ if (likely ((status & (STS_INT|STS_ERR)) != 0)) { - if (likely ((status & STS_ERR) == 0)) + if (likely ((status & STS_ERR) == 0)) { INCR(ehci->stats.normal); - else + } else { + /* Force to check port status */ + if (ehci->has_ci_pec_bug) + status |= STS_PCD; INCR(ehci->stats.error); + } bh = 1; }
diff --git a/drivers/usb/host/ehci-hub.c b/drivers/usb/host/ehci-hub.c index c4f6a2559a987..0350c03dc97a1 100644 --- a/drivers/usb/host/ehci-hub.c +++ b/drivers/usb/host/ehci-hub.c @@ -674,7 +674,8 @@ ehci_hub_status_data (struct usb_hcd *hcd, char *buf)
if ((temp & mask) != 0 || test_bit(i, &ehci->port_c_suspend) || (ehci->reset_done[i] && time_after_eq( - jiffies, ehci->reset_done[i]))) { + jiffies, ehci->reset_done[i])) + || ehci_has_ci_pec_bug(ehci, temp)) { if (i < 7) buf [0] |= 1 << (i + 1); else @@ -874,6 +875,13 @@ int ehci_hub_control( if (temp & PORT_PEC) status |= USB_PORT_STAT_C_ENABLE << 16;
+ if (ehci_has_ci_pec_bug(ehci, temp)) { + status |= USB_PORT_STAT_C_ENABLE << 16; + ehci_info(ehci, + "PE is cleared by HW port:%d PORTSC:%08x\n", + wIndex + 1, temp); + } + if ((temp & PORT_OCC) && (!ignore_oc && !ehci->spurious_oc)){ status |= USB_PORT_STAT_C_OVERCURRENT << 16;
diff --git a/drivers/usb/host/ehci.h b/drivers/usb/host/ehci.h index fdd073cc053b8..9888ca5f5f36f 100644 --- a/drivers/usb/host/ehci.h +++ b/drivers/usb/host/ehci.h @@ -207,6 +207,7 @@ struct ehci_hcd { /* one per controller */ unsigned has_fsl_port_bug:1; /* FreeScale */ unsigned has_fsl_hs_errata:1; /* Freescale HS quirk */ unsigned has_fsl_susp_errata:1; /* NXP SUSP quirk */ + unsigned has_ci_pec_bug:1; /* ChipIdea PEC bug */ unsigned big_endian_mmio:1; unsigned big_endian_desc:1; unsigned big_endian_capbase:1; @@ -706,6 +707,15 @@ ehci_port_speed(struct ehci_hcd *ehci, unsigned int portsc) */ #define ehci_has_fsl_susp_errata(e) ((e)->has_fsl_susp_errata)
+/* + * Some Freescale/NXP processors using ChipIdea IP have a bug in which + * disabling the port (PE is cleared) does not cause PEC to be asserted + * when frame babble is detected. + */ +#define ehci_has_ci_pec_bug(e, portsc) \ + ((e)->has_ci_pec_bug && ((e)->command & CMD_PSE) \ + && !(portsc & PORT_PEC) && !(portsc & PORT_PE)) + /* * While most USB host controllers implement their registers in * little-endian format, a minority (celleb companion chip) implement