From: Marek Vasut marex@denx.de
[ Upstream commit 9ad98319e95263469d8ca2cb543c37c5a2f40980 ]
On the production revision of the SoM, 587-200, the PHY reset GPIO and touchscreen IRQs are swapped to prevent collision between EXTi IRQs, reflect that in DT.
Fixes: 34e0c7847dcf ("ARM: dts: stm32: Add DH Electronics DHCOM STM32MP1 SoM and PDK2 board") Signed-off-by: Marek Vasut marex@denx.de Cc: Alexandre Torgue alexandre.torgue@st.com Cc: Maxime Coquelin mcoquelin.stm32@gmail.com Cc: Patrice Chotard patrice.chotard@st.com Cc: Patrick Delaunay patrick.delaunay@st.com Cc: linux-stm32@st-md-mailman.stormreply.com To: linux-arm-kernel@lists.infradead.org Signed-off-by: Alexandre Torgue alexandre.torgue@st.com Signed-off-by: Sasha Levin sashal@kernel.org --- arch/arm/boot/dts/stm32mp15xx-dhcom-som.dtsi | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/arch/arm/boot/dts/stm32mp15xx-dhcom-som.dtsi b/arch/arm/boot/dts/stm32mp15xx-dhcom-som.dtsi index d30a3c60da9b0..a87ebc4843963 100644 --- a/arch/arm/boot/dts/stm32mp15xx-dhcom-som.dtsi +++ b/arch/arm/boot/dts/stm32mp15xx-dhcom-som.dtsi @@ -117,7 +117,7 @@ ðernet0 { max-speed = <100>; phy-handle = <&phy0>; st,eth-ref-clk-sel; - phy-reset-gpios = <&gpioh 15 GPIO_ACTIVE_LOW>; + phy-reset-gpios = <&gpioh 3 GPIO_ACTIVE_LOW>;
mdio0 { #address-cells = <1>; @@ -285,7 +285,7 @@ touchscreen@49 { compatible = "ti,tsc2004"; reg = <0x49>; vio-supply = <&v3v3>; - interrupts-extended = <&gpioh 3 IRQ_TYPE_EDGE_FALLING>; + interrupts-extended = <&gpioh 15 IRQ_TYPE_EDGE_FALLING>; };
eeprom@50 {