From: Dmitry Osipenko digetx@gmail.com
[ Upstream commit efe2175478d5237949e33c84d9a722fc084b218c ]
Pin control needs to be activated by setting the enable bit, otherwise hardware rejects all pin changes. Previously this stayed unnoticed on Nexus 7 because pin control was enabled by default after rebooting from downstream kernel, which uses driver that enables the bit and charger registers are non-volatile until power supply (battery) is disconnected. Configure the pin control enable bit. This fixes the potentially never-enabled charging on devices that use pin control.
Signed-off-by: Dmitry Osipenko digetx@gmail.com Signed-off-by: Sebastian Reichel sebastian.reichel@collabora.com Signed-off-by: Sasha Levin sashal@kernel.org --- drivers/power/supply/smb347-charger.c | 10 ++++++++++ 1 file changed, 10 insertions(+)
diff --git a/drivers/power/supply/smb347-charger.c b/drivers/power/supply/smb347-charger.c index 3376f42d46c3..25d239f2330e 100644 --- a/drivers/power/supply/smb347-charger.c +++ b/drivers/power/supply/smb347-charger.c @@ -56,6 +56,7 @@ #define CFG_PIN_EN_CTRL_ACTIVE_LOW 0x60 #define CFG_PIN_EN_APSD_IRQ BIT(1) #define CFG_PIN_EN_CHARGER_ERROR BIT(2) +#define CFG_PIN_EN_CTRL BIT(4) #define CFG_THERM 0x07 #define CFG_THERM_SOFT_HOT_COMPENSATION_MASK 0x03 #define CFG_THERM_SOFT_HOT_COMPENSATION_SHIFT 0 @@ -725,6 +726,15 @@ static int smb347_hw_init(struct smb347_charger *smb) if (ret < 0) goto fail;
+ /* Activate pin control, making it writable. */ + switch (smb->enable_control) { + case SMB3XX_CHG_ENABLE_PIN_ACTIVE_LOW: + case SMB3XX_CHG_ENABLE_PIN_ACTIVE_HIGH: + ret = regmap_set_bits(smb->regmap, CFG_PIN, CFG_PIN_EN_CTRL); + if (ret < 0) + goto fail; + } + /* * Make the charging functionality controllable by a write to the * command register unless pin control is specified in the platform