Hi Frieder,
Frieder Schrempf frieder.schrempf@kontron.de wrote on Mon, 30 Aug 2021 11:18:50 +0200:
On 30.08.21 10:41, Miquel Raynal wrote:
Hi Frieder,
Frieder Schrempf frieder@fris.de wrote on Mon, 30 Aug 2021 09:21:07 +0200:
From: Frieder Schrempf frieder.schrempf@kontron.de
The new generic NAND ECC framework stores the configuration and requirements in separate places since commit 93ef92f6f422 (" mtd: nand: Use the new generic ECC object "). In 5.10.x The SPI NAND layer still uses only the requirements to track the ECC properties. This mismatch leads to values of zero being used for ECC strength and step_size in the SPI NAND layer wherever nanddev_get_ecc_conf() is used and therefore breaks the SPI NAND on-die ECC support in 5.10.x.
By using nanddev_get_ecc_requirements() instead of nanddev_get_ecc_conf() for SPI NAND, we make sure that the correct parameters for the detected chip are used. In later versions (5.11.x) this is fixed anyway with the implementation of the SPI NAND on-die ECC engine.
Cc: stable@vger.kernel.org # 5.10.x Reported-by: voice INTER connect GmbH developer@voiceinterconnect.de Signed-off-by: Frieder Schrempf frieder.schrempf@kontron.de
Why not just reverting 9a333a72c1d0 ("mtd: spinand: Use nanddev_get_ecc_conf() when relevant")? I think using this "new" nanddev_get_ecc_requirements() helper because it fits the purpose even if it is wrong [1] doesn't bring the right information. I know it is strictly equivalent but I would personally prefer keeping the old writing "nand->eccreq.xxxx".
I think reverting 9a333a72c1d0 to use nand->eccreq.xxxx doesn't work as the eccreq member has already been removed in 93ef92f6f422 ("mtd: nand: Use the new generic ECC object"). So we would need to revert this commit, too. That would work for the SPI NAND layer, but might have implications on RAW NAND as it already uses the new generic ECC object with 'ctx.conf' and 'requirements'. At least I can't tell how this would affect the RAW NAND layer.
I missed that, you're right.
Acked-by: Miquel Raynal miquel.raynal@bootlin.com
[1] We don't want the requirements but the actual current configuration here, which was the primary purpose of the initial patch which ended being a mistake at that point in time because the SPI-NAND core was not ready yet.
Thanks, Miquèl
Thanks, Miquèl