From: Madalin Bucur madalin.bucur@oss.nxp.com
commit d79e9d7c1e4ba5f95f2ff3541880c40ea9722212 upstream.
The correct setting for the RGMII ports on LS1046ARDB is to enable delay on both Rx and Tx so the interface mode used must be PHY_INTERFACE_MODE_RGMII_ID.
Since commit 1b3047b5208a80 ("net: phy: realtek: add support for configuring the RX delay on RTL8211F") the Realtek 8211F PHY driver has control over the RGMII RX delay and it is disabling it for RGMII_TXID. The LS1046ARDB uses two such PHYs in RGMII_ID mode but in the device tree the mode was described as "rgmii".
Changing the phy-connection-type to "rgmii-id" to address the issue.
Fixes: 3fa395d2c48a ("arm64: dts: add LS1046A DPAA FMan nodes") Signed-off-by: Madalin Bucur madalin.bucur@oss.nxp.com Signed-off-by: David S. Miller davem@davemloft.net Signed-off-by: Greg Kroah-Hartman gregkh@linuxfoundation.org
--- arch/arm64/boot/dts/freescale/fsl-ls1046a-rdb.dts | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-)
--- a/arch/arm64/boot/dts/freescale/fsl-ls1046a-rdb.dts +++ b/arch/arm64/boot/dts/freescale/fsl-ls1046a-rdb.dts @@ -131,12 +131,12 @@ &fman0 { ethernet@e4000 { phy-handle = <&rgmii_phy1>; - phy-connection-type = "rgmii"; + phy-connection-type = "rgmii-id"; };
ethernet@e6000 { phy-handle = <&rgmii_phy2>; - phy-connection-type = "rgmii"; + phy-connection-type = "rgmii-id"; };
ethernet@e8000 {