At least on PXA3xx platforms, enabling RDY interrupts in the NDCR register will only cause the IRQ to latch when the RDY lanes are changing, and not in case they are already asserted.
This means that if the controller finished the command in flight before marvell_nfc_wait_op() is called, that function will wait for a change in the bit that can't ever happen as it is already set.
To mitigate this race, check for the RDY bits after the IRQ was enabled, and only sleep on the condition if the controller isn't ready yet.
This fixes a bug that was observed with a NAND chip that holds a UBIFS parition on which file system stress tests were executed. When marvell_nfc_wait_op() reports an error, UBI/UBIFS will eventually mount the filesystem read-only, reporting lots of warnings along the way.
Fixes: 02f26ecf8c77 mtd: nand: add reworked Marvell NAND controller driver Cc: stable@vger.kernel.org Signed-off-by: Daniel Mack daniel@zonque.org --- drivers/mtd/nand/raw/marvell_nand.c | 14 +++++++++++--- 1 file changed, 11 insertions(+), 3 deletions(-)
diff --git a/drivers/mtd/nand/raw/marvell_nand.c b/drivers/mtd/nand/raw/marvell_nand.c index 666f34b58dec..e96ec7b9a152 100644 --- a/drivers/mtd/nand/raw/marvell_nand.c +++ b/drivers/mtd/nand/raw/marvell_nand.c @@ -613,7 +613,8 @@ static int marvell_nfc_wait_cmdd(struct nand_chip *chip) static int marvell_nfc_wait_op(struct nand_chip *chip, unsigned int timeout_ms) { struct marvell_nfc *nfc = to_marvell_nfc(chip->controller); - int ret; + int ret = -EALREADY; + u32 st;
/* Timeout is expressed in ms */ if (!timeout_ms) @@ -622,8 +623,15 @@ static int marvell_nfc_wait_op(struct nand_chip *chip, unsigned int timeout_ms) init_completion(&nfc->complete);
marvell_nfc_enable_int(nfc, NDCR_RDYM); - ret = wait_for_completion_timeout(&nfc->complete, - msecs_to_jiffies(timeout_ms)); + + /* + * Check if the NDSR_RDY bits have already been set before the + * interrupt was enabled. + */ + st = readl_relaxed(nfc->regs + NDSR); + if (!(st & (NDSR_RDY(0) | NDSR_RDY(1)))) + ret = wait_for_completion_timeout(&nfc->complete, + msecs_to_jiffies(timeout_ms)); marvell_nfc_disable_int(nfc, NDCR_RDYM); marvell_nfc_clear_int(nfc, NDSR_RDY(0) | NDSR_RDY(1)); if (!ret) {