As per Hardware Programming Guide, when configuring pin as output, set the pin value before setting output-enable (OE). Similar approach is in main SoC TLMM pin controller.
Cc: stable@vger.kernel.org Fixes: 6e261d1090d6 ("pinctrl: qcom: Add sm8250 lpass lpi pinctrl driver") Signed-off-by: Krzysztof Kozlowski krzysztof.kozlowski@linaro.org --- drivers/pinctrl/qcom/pinctrl-lpass-lpi.c | 14 +++++++++----- 1 file changed, 9 insertions(+), 5 deletions(-)
diff --git a/drivers/pinctrl/qcom/pinctrl-lpass-lpi.c b/drivers/pinctrl/qcom/pinctrl-lpass-lpi.c index 87920257bb73..27fc8b671954 100644 --- a/drivers/pinctrl/qcom/pinctrl-lpass-lpi.c +++ b/drivers/pinctrl/qcom/pinctrl-lpass-lpi.c @@ -221,6 +221,15 @@ static int lpi_config_set(struct pinctrl_dev *pctldev, unsigned int group, } }
+ /* + * As per Hardware Programming Guide, when configuring pin as output, + * set the pin value before setting output-enable (OE). + */ + if (output_enabled) { + val = u32_encode_bits(value ? 1 : 0, LPI_GPIO_VALUE_OUT_MASK); + lpi_gpio_write(pctrl, group, LPI_GPIO_VALUE_REG, val); + } + val = lpi_gpio_read(pctrl, group, LPI_GPIO_CFG_REG);
u32p_replace_bits(&val, pullup, LPI_GPIO_PULL_MASK); @@ -230,11 +239,6 @@ static int lpi_config_set(struct pinctrl_dev *pctldev, unsigned int group,
lpi_gpio_write(pctrl, group, LPI_GPIO_CFG_REG, val);
- if (output_enabled) { - val = u32_encode_bits(value ? 1 : 0, LPI_GPIO_VALUE_OUT_MASK); - lpi_gpio_write(pctrl, group, LPI_GPIO_VALUE_REG, val); - } - return 0; }