From: Rafael J. Wysocki rafael.j.wysocki@intel.com
[ Upstream commit 0e00392a895c95c6d12d42158236c8862a2f43f2 ]
PME signaling is only enabled by __pci_enable_wake() if the target device can signal PME from the given target power state (to avoid pointless reconfiguration of the device), but if the hierarchy above the device goes into D3cold, the device itself will end up in D3cold too, so if it can signal PME from D3cold, it should be enabled to do so in __pci_enable_wake().
[Note that if the device does not end up in D3cold and it cannot signal PME from the original target power state, it will not signal PME, so in that case the behavior does not change.]
Link: https://lore.kernel.org/linux-pm/3149540.aeNJFYEL58@kreacher/ Fixes: 5bcc2fb4e815 ("PCI PM: Simplify PCI wake-up code") Reported-by: Mika Westerberg mika.westerberg@linux.intel.com Reported-by: Utkarsh H Patel utkarsh.h.patel@intel.com Reported-by: Koba Ko koba.ko@canonical.com Signed-off-by: Rafael J. Wysocki rafael.j.wysocki@intel.com Reviewed-by: Mika Westerberg mika.westerberg@linux.intel.com Tested-by: Mika Westerberg mika.westerberg@linux.intel.com Signed-off-by: Sasha Levin sashal@kernel.org --- drivers/pci/pci.c | 9 ++++++++- 1 file changed, 8 insertions(+), 1 deletion(-)
diff --git a/drivers/pci/pci.c b/drivers/pci/pci.c index 9c4ac6face3b..58c33b65d451 100644 --- a/drivers/pci/pci.c +++ b/drivers/pci/pci.c @@ -2253,7 +2253,14 @@ static int __pci_enable_wake(struct pci_dev *dev, pci_power_t state, bool enable if (enable) { int error;
- if (pci_pme_capable(dev, state)) + /* + * Enable PME signaling if the device can signal PME from + * D3cold regardless of whether or not it can signal PME from + * the current target state, because that will allow it to + * signal PME when the hierarchy above it goes into D3cold and + * the device itself ends up in D3cold as a result of that. + */ + if (pci_pme_capable(dev, state) || pci_pme_capable(dev, PCI_D3cold)) pci_pme_active(dev, true); else ret = 1;