4.18-stable review patch. If anyone has any objections, please let me know.
------------------
From: Akshu Agrawal akshu.agrawal@amd.com
[ Upstream commit 2a665dba016d5493c7d826fec82b0cb643b30d42 ]
HW register descriptions says: "DMA Channel Reset...Software must confirm that this bit is cleared before reprogramming any of the channel configuration registers." There could be cases where dma stop errored out leaving dma channel in reset state. We need to ensure that before the start of another dma, channel is out of the reset state.
Signed-off-by: Akshu Agrawal akshu.agrawal@amd.com Signed-off-by: Mark Brown broonie@kernel.org Signed-off-by: Sasha Levin alexander.levin@microsoft.com Signed-off-by: Greg Kroah-Hartman gregkh@linuxfoundation.org --- sound/soc/amd/acp-pcm-dma.c | 21 +++++++++++++++++++++ 1 file changed, 21 insertions(+)
--- a/sound/soc/amd/acp-pcm-dma.c +++ b/sound/soc/amd/acp-pcm-dma.c @@ -16,6 +16,7 @@ #include <linux/module.h> #include <linux/delay.h> #include <linux/io.h> +#include <linux/iopoll.h> #include <linux/sizes.h> #include <linux/pm_runtime.h>
@@ -184,6 +185,24 @@ static void config_dma_descriptor_in_sra acp_reg_write(descr_info->xfer_val, acp_mmio, mmACP_SRBM_Targ_Idx_Data); }
+static void pre_config_reset(void __iomem *acp_mmio, u16 ch_num) +{ + u32 dma_ctrl; + int ret; + + /* clear the reset bit */ + dma_ctrl = acp_reg_read(acp_mmio, mmACP_DMA_CNTL_0 + ch_num); + dma_ctrl &= ~ACP_DMA_CNTL_0__DMAChRst_MASK; + acp_reg_write(dma_ctrl, acp_mmio, mmACP_DMA_CNTL_0 + ch_num); + /* check the reset bit before programming configuration registers */ + ret = readl_poll_timeout(acp_mmio + ((mmACP_DMA_CNTL_0 + ch_num) * 4), + dma_ctrl, + !(dma_ctrl & ACP_DMA_CNTL_0__DMAChRst_MASK), + 100, ACP_DMA_RESET_TIME); + if (ret < 0) + pr_err("Failed to clear reset of channel : %d\n", ch_num); +} + /* * Initialize the DMA descriptor information for transfer between * system memory <-> ACP SRAM @@ -238,6 +257,7 @@ static void set_acp_sysmem_dma_descripto config_dma_descriptor_in_sram(acp_mmio, dma_dscr_idx, &dmadscr[i]); } + pre_config_reset(acp_mmio, ch); config_acp_dma_channel(acp_mmio, ch, dma_dscr_idx - 1, NUM_DSCRS_PER_CHANNEL, @@ -277,6 +297,7 @@ static void set_acp_to_i2s_dma_descripto config_dma_descriptor_in_sram(acp_mmio, dma_dscr_idx, &dmadscr[i]); } + pre_config_reset(acp_mmio, ch); /* Configure the DMA channel with the above descriptore */ config_acp_dma_channel(acp_mmio, ch, dma_dscr_idx - 1, NUM_DSCRS_PER_CHANNEL,