From: Pali Rohár pali@kernel.org
commit d0c6a3475b033960e85ae2bf176b14cab0a627d2 upstream.
Move code which belongs to link training (delays and resets) into advk_pcie_train_link() function, so everything related to link training, including timings is at one place.
After experiments it can be observed that link training in aardvark hardware is very sensitive to timings and delays, so it is a good idea to have this code at the same place as link training calls.
This patch does not change behavior of aardvark initialization.
Link: https://lore.kernel.org/r/20200907111038.5811-6-pali@kernel.org Tested-by: Marek Behún marek.behun@nic.cz Signed-off-by: Pali Rohár pali@kernel.org Signed-off-by: Lorenzo Pieralisi lorenzo.pieralisi@arm.com Signed-off-by: Marek Behún kabel@kernel.org Signed-off-by: Greg Kroah-Hartman gregkh@linuxfoundation.org --- drivers/pci/controller/pci-aardvark.c | 64 ++++++++++++++++++---------------- 1 file changed, 34 insertions(+), 30 deletions(-)
--- a/drivers/pci/controller/pci-aardvark.c +++ b/drivers/pci/controller/pci-aardvark.c @@ -229,6 +229,25 @@ static int advk_pcie_wait_for_link(struc return -ETIMEDOUT; }
+static void advk_pcie_issue_perst(struct advk_pcie *pcie) +{ + u32 reg; + + if (!pcie->reset_gpio) + return; + + /* PERST does not work for some cards when link training is enabled */ + reg = advk_readl(pcie, PCIE_CORE_CTRL0_REG); + reg &= ~LINK_TRAINING_EN; + advk_writel(pcie, reg, PCIE_CORE_CTRL0_REG); + + /* 10ms delay is needed for some cards */ + dev_info(&pcie->pdev->dev, "issuing PERST via reset GPIO for 10ms\n"); + gpiod_set_value_cansleep(pcie->reset_gpio, 1); + usleep_range(10000, 11000); + gpiod_set_value_cansleep(pcie->reset_gpio, 0); +} + static int advk_pcie_train_at_gen(struct advk_pcie *pcie, int gen) { int ret, neg_gen; @@ -277,6 +296,21 @@ static void advk_pcie_train_link(struct int neg_gen = -1, gen;
/* + * Reset PCIe card via PERST# signal. Some cards are not detected + * during link training when they are in some non-initial state. + */ + advk_pcie_issue_perst(pcie); + + /* + * PERST# signal could have been asserted by pinctrl subsystem before + * probe() callback has been called or issued explicitly by reset gpio + * function advk_pcie_issue_perst(), making the endpoint going into + * fundamental reset. As required by PCI Express spec a delay for at + * least 100ms after such a reset before link training is needed. + */ + msleep(PCI_PM_D3COLD_WAIT); + + /* * Try link training at link gen specified by device tree property * 'max-link-speed'. If this fails, iteratively train at lower gen. */ @@ -308,31 +342,10 @@ err: dev_err(dev, "link never came up\n"); }
-static void advk_pcie_issue_perst(struct advk_pcie *pcie) -{ - u32 reg; - - if (!pcie->reset_gpio) - return; - - /* PERST does not work for some cards when link training is enabled */ - reg = advk_readl(pcie, PCIE_CORE_CTRL0_REG); - reg &= ~LINK_TRAINING_EN; - advk_writel(pcie, reg, PCIE_CORE_CTRL0_REG); - - /* 10ms delay is needed for some cards */ - dev_info(&pcie->pdev->dev, "issuing PERST via reset GPIO for 10ms\n"); - gpiod_set_value_cansleep(pcie->reset_gpio, 1); - usleep_range(10000, 11000); - gpiod_set_value_cansleep(pcie->reset_gpio, 0); -} - static void advk_pcie_setup_hw(struct advk_pcie *pcie) { u32 reg;
- advk_pcie_issue_perst(pcie); - /* Set to Direct mode */ reg = advk_readl(pcie, CTRL_CONFIG_REG); reg &= ~(CTRL_MODE_MASK << CTRL_MODE_SHIFT); @@ -404,15 +417,6 @@ static void advk_pcie_setup_hw(struct ad reg |= PIO_CTRL_ADDR_WIN_DISABLE; advk_writel(pcie, reg, PIO_CTRL);
- /* - * PERST# signal could have been asserted by pinctrl subsystem before - * probe() callback has been called or issued explicitly by reset gpio - * function advk_pcie_issue_perst(), making the endpoint going into - * fundamental reset. As required by PCI Express spec a delay for at - * least 100ms after such a reset before link training is needed. - */ - msleep(PCI_PM_D3COLD_WAIT); - advk_pcie_train_link(pcie);
reg = advk_readl(pcie, PCIE_CORE_CMD_STATUS_REG);