From: Krzysztof Kozlowski krzysztof.kozlowski@linaro.org
[ Upstream commit ec5dba73f7ba10797904cf18092d2e6975a22147 ]
The shutdown GPIO is active low (SD_N), but this depends on actual board layout. Linux drivers should only care about logical state, where high (1) means shutdown and low (0) means do not shutdown.
Invert the GPIO to match logical value.
Fixes: 43b8c7dc85a1 ("ASoC: codecs: add wsa883x amplifier support") Signed-off-by: Krzysztof Kozlowski krzysztof.kozlowski@linaro.org Reviewed-by: Srinivas Kandagatla srinivas.kandagatla@linaro.org Link: https://lore.kernel.org/r/20221110133512.478831-2-krzysztof.kozlowski@linaro... Signed-off-by: Mark Brown broonie@kernel.org Signed-off-by: Sasha Levin sashal@kernel.org --- sound/soc/codecs/wsa883x.c | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/sound/soc/codecs/wsa883x.c b/sound/soc/codecs/wsa883x.c index c7b10bbfba7e..77a7dd3cf495 100644 --- a/sound/soc/codecs/wsa883x.c +++ b/sound/soc/codecs/wsa883x.c @@ -1392,7 +1392,7 @@ static int wsa883x_probe(struct sdw_slave *pdev, }
wsa883x->sd_n = devm_gpiod_get_optional(&pdev->dev, "powerdown", - GPIOD_FLAGS_BIT_NONEXCLUSIVE); + GPIOD_FLAGS_BIT_NONEXCLUSIVE | GPIOD_OUT_HIGH); if (IS_ERR(wsa883x->sd_n)) { dev_err(&pdev->dev, "Shutdown Control GPIO not found\n"); ret = PTR_ERR(wsa883x->sd_n); @@ -1411,7 +1411,7 @@ static int wsa883x_probe(struct sdw_slave *pdev, pdev->prop.simple_clk_stop_capable = true; pdev->prop.sink_dpn_prop = wsa_sink_dpn_prop; pdev->prop.scp_int1_mask = SDW_SCP_INT1_BUS_CLASH | SDW_SCP_INT1_PARITY; - gpiod_direction_output(wsa883x->sd_n, 1); + gpiod_direction_output(wsa883x->sd_n, 0);
wsa883x->regmap = devm_regmap_init_sdw(pdev, &wsa883x_regmap_config); if (IS_ERR(wsa883x->regmap)) {