From: Andrew F. Davis afd@ti.com
commit 66f030eac257a572fbedab3d9646d87d647351fd upstream.
TI-SCI firmware will only respond to messages when the TI_SCI_FLAG_REQ_ACK_ON_PROCESSED flag is set. Most messages already do this, set this for the ones that do not.
This will be enforced in future firmware that better match the TI-SCI specifications, this patch will not break users of existing firmware.
Fixes: aa276781a64a ("firmware: Add basic support for TI System Control Interface (TI-SCI) protocol") Signed-off-by: Andrew F. Davis afd@ti.com Acked-by: Nishanth Menon nm@ti.com Tested-by: Alejandro Hernandez ajhernandez@ti.com Signed-off-by: Tero Kristo t-kristo@ti.com Signed-off-by: Santosh Shilimkar santosh.shilimkar@oracle.com Signed-off-by: Greg Kroah-Hartman gregkh@linuxfoundation.org
--- drivers/firmware/ti_sci.c | 8 ++++---- 1 file changed, 4 insertions(+), 4 deletions(-)
--- a/drivers/firmware/ti_sci.c +++ b/drivers/firmware/ti_sci.c @@ -471,9 +471,9 @@ static int ti_sci_cmd_get_revision(struc struct ti_sci_xfer *xfer; int ret;
- /* No need to setup flags since it is expected to respond */ xfer = ti_sci_get_one_xfer(info, TI_SCI_MSG_VERSION, - 0x0, sizeof(struct ti_sci_msg_hdr), + TI_SCI_FLAG_REQ_ACK_ON_PROCESSED, + sizeof(struct ti_sci_msg_hdr), sizeof(*rev_info)); if (IS_ERR(xfer)) { ret = PTR_ERR(xfer); @@ -601,9 +601,9 @@ static int ti_sci_get_device_state(const info = handle_to_ti_sci_info(handle); dev = info->dev;
- /* Response is expected, so need of any flags */ xfer = ti_sci_get_one_xfer(info, TI_SCI_MSG_GET_DEVICE_STATE, - 0, sizeof(*req), sizeof(*resp)); + TI_SCI_FLAG_REQ_ACK_ON_PROCESSED, + sizeof(*req), sizeof(*resp)); if (IS_ERR(xfer)) { ret = PTR_ERR(xfer); dev_err(dev, "Message alloc failed(%d)\n", ret);