From: Remi Pommarel repk@triplefau.lt
commit f4c7d053d7f77cd5c1a1ba7c7ce085ddba13d1d7 upstream.
When configuring pcie reset pin from gpio (e.g. initially set by u-boot) to pcie function this pin goes low for a brief moment asserting the PERST# signal. Thus connected device enters fundamental reset process and link configuration can only begin after a minimal 100ms delay (see [1]).
Because the pin configuration comes from the "default" pinctrl it is implicitly configured before the probe callback is called:
driver_probe_device() really_probe() ... pinctrl_bind_pins() /* Here pin goes from gpio to PCIE reset function and PERST# is asserted */ ... drv->probe()
[1] "PCI Express Base Specification", REV. 4.0 PCI Express, February 19 2014, 6.6.1 Conventional Reset
Signed-off-by: Remi Pommarel repk@triplefau.lt Signed-off-by: Lorenzo Pieralisi lorenzo.pieralisi@arm.com Acked-by: Thomas Petazzoni thomas.petazzoni@bootlin.com Signed-off-by: Marek Behún kabel@kernel.org Signed-off-by: Greg Kroah-Hartman gregkh@linuxfoundation.org --- drivers/pci/host/pci-aardvark.c | 8 ++++++++ 1 file changed, 8 insertions(+)
--- a/drivers/pci/host/pci-aardvark.c +++ b/drivers/pci/host/pci-aardvark.c @@ -362,6 +362,14 @@ static void advk_pcie_setup_hw(struct ad reg |= PIO_CTRL_ADDR_WIN_DISABLE; advk_writel(pcie, reg, PIO_CTRL);
+ /* + * PERST# signal could have been asserted by pinctrl subsystem before + * probe() callback has been called, making the endpoint going into + * fundamental reset. As required by PCI Express spec a delay for at + * least 100ms after such a reset before link training is needed. + */ + msleep(PCI_PM_D3COLD_WAIT); + /* Start link training */ reg = advk_readl(pcie, PCIE_CORE_LINK_CTRL_STAT_REG); reg |= PCIE_CORE_LINK_TRAINING;