From: Pali Rohár pali@kernel.org
commit b64d814257b027e29a474bcd660f6372490138c7 upstream.
Espressobin boards have 3 ethernet ports and some of them got assigned more then one MAC address. MAC addresses are stored in U-Boot environment.
Since commit a2c7023f7075c ("net: dsa: read mac address from DT for slave device") kernel can use MAC addresses from DT for particular DSA port.
Currently Espressobin DTS file contains alias just for ethernet0.
This patch defines additional ethernet aliases in Espressobin DTS files, so bootloader can fill correct MAC address for DSA switch ports if more MAC addresses were specified.
DT alias ethernet1 is used for wan port, DT aliases ethernet2 and ethernet3 are used for lan ports for both Espressobin revisions (V5 and V7).
Fixes: 5253cb8c00a6f ("arm64: dts: marvell: espressobin: add ethernet alias") Cc: stable@vger.kernel.org # a2c7023f7075c: dsa: read mac address Signed-off-by: Pali Rohár pali@kernel.org Reviewed-by: Andrew Lunn andrew@lunn.ch Reviewed-by: Andre Heider a.heider@gmail.com Signed-off-by: Gregory CLEMENT gregory.clement@bootlin.com [pali: Backported Espressobin rev V5 changes to 5.4 and 4.19 versions] Signed-off-by: Greg Kroah-Hartman gregkh@linuxfoundation.org
--- arch/arm64/boot/dts/marvell/armada-3720-espressobin.dts | 12 ++++++++---- 1 file changed, 8 insertions(+), 4 deletions(-)
--- a/arch/arm64/boot/dts/marvell/armada-3720-espressobin.dts +++ b/arch/arm64/boot/dts/marvell/armada-3720-espressobin.dts @@ -21,6 +21,10 @@
aliases { ethernet0 = ð0; + /* for dsa slave device */ + ethernet1 = &switch0port1; + ethernet2 = &switch0port2; + ethernet3 = &switch0port3; serial0 = &uart0; serial1 = &uart1; }; @@ -147,7 +151,7 @@ #address-cells = <1>; #size-cells = <0>;
- port@0 { + switch0port0: port@0 { reg = <0>; label = "cpu"; ethernet = <ð0>; @@ -158,19 +162,19 @@ }; };
- port@1 { + switch0port1: port@1 { reg = <1>; label = "wan"; phy-handle = <&switch0phy0>; };
- port@2 { + switch0port2: port@2 { reg = <2>; label = "lan0"; phy-handle = <&switch0phy1>; };
- port@3 { + switch0port3: port@3 { reg = <3>; label = "lan1"; phy-handle = <&switch0phy2>;