From: Joakim Zhang qiangqing.zhang@nxp.com
[ Upstream commit 049d919168458ac54e7fad27cd156a958b042d2f ]
When disabling a counter from ddr_perf_event_stop(), the counter value is reset to 0 at the same time.
Preserve the counter value by performing a read-modify-write of the PMU register and clearing only the enable bit.
Signed-off-by: Joakim Zhang qiangqing.zhang@nxp.com Signed-off-by: Will Deacon will@kernel.org Signed-off-by: Sasha Levin sashal@kernel.org --- drivers/perf/fsl_imx8_ddr_perf.c | 10 ++++++---- 1 file changed, 6 insertions(+), 4 deletions(-)
diff --git a/drivers/perf/fsl_imx8_ddr_perf.c b/drivers/perf/fsl_imx8_ddr_perf.c index 95dca2cb52650..90884d14f95fa 100644 --- a/drivers/perf/fsl_imx8_ddr_perf.c +++ b/drivers/perf/fsl_imx8_ddr_perf.c @@ -388,9 +388,10 @@ static void ddr_perf_counter_enable(struct ddr_pmu *pmu, int config,
if (enable) { /* - * must disable first, then enable again - * otherwise, cycle counter will not work - * if previous state is enabled. + * cycle counter is special which should firstly write 0 then + * write 1 into CLEAR bit to clear it. Other counters only + * need write 0 into CLEAR bit and it turns out to be 1 by + * hardware. Below enable flow is harmless for all counters. */ writel(0, pmu->base + reg); val = CNTL_EN | CNTL_CLEAR; @@ -398,7 +399,8 @@ static void ddr_perf_counter_enable(struct ddr_pmu *pmu, int config, writel(val, pmu->base + reg); } else { /* Disable counter */ - writel(0, pmu->base + reg); + val = readl_relaxed(pmu->base + reg) & CNTL_EN_MASK; + writel(val, pmu->base + reg); } }