4.18-stable review patch. If anyone has any objections, please let me know.
------------------
From: Jian Shen shenjian15@huawei.com
[ Upstream commit 60081dcc4fce385ade26d3145b2479789df0b7e5 ]
For marvell phy m88e1510, bit SUPPORTED_FIBRE of phydev->supported is default on. Both phy_resume() and phy_suspend() will check the SUPPORTED_FIBRE bit and write register of fibre page.
Currently in hns3 driver, the SUPPORTED_FIBRE bit will be cleared after phy_connect_direct() finished. Because phy_resume() is called in phy_connect_direct(), and phy_suspend() is called when disconnect phy device, so the operation for fibre page register is not symmetrical. It will cause phy link issue when reload hns3 driver.
This patch fixes it by disable the SUPPORTED_FIBRE before connecting phy.
Fixes: 256727da7395 ("net: hns3: Add MDIO support to HNS3 Ethernet driver for hip08 SoC") Signed-off-by: Jian Shen shenjian15@huawei.com Signed-off-by: Peng Li lipeng321@huawei.com Signed-off-by: Salil Mehta salil.mehta@huawei.com Signed-off-by: David S. Miller davem@davemloft.net Signed-off-by: Sasha Levin alexander.levin@microsoft.com Signed-off-by: Greg Kroah-Hartman gregkh@linuxfoundation.org --- drivers/net/ethernet/hisilicon/hns3/hns3pf/hclge_mdio.c | 2 ++ 1 file changed, 2 insertions(+)
--- a/drivers/net/ethernet/hisilicon/hns3/hns3pf/hclge_mdio.c +++ b/drivers/net/ethernet/hisilicon/hns3/hns3pf/hclge_mdio.c @@ -208,6 +208,8 @@ int hclge_mac_start_phy(struct hclge_dev if (!phydev) return 0;
+ phydev->supported &= ~SUPPORTED_FIBRE; + ret = phy_connect_direct(netdev, phydev, hclge_mac_adjust_link, PHY_INTERFACE_MODE_SGMII);