Any write with either dd or flashcp to a device driven by the spear_smi.c driver will pass through the spear_smi_cpy_toio() function. This function will get called for chunks of up to 256 bytes. If the amount of data is smaller, we may have a problem if the data length is not 4-byte aligned. In this situation, the kernel panics during the memcpy:
# dd if=/dev/urandom bs=1001 count=1 of=/dev/mtd6 spear_smi_cpy_toio [620] dest c9070000, src c7be8800, len 256 spear_smi_cpy_toio [620] dest c9070100, src c7be8900, len 256 spear_smi_cpy_toio [620] dest c9070200, src c7be8a00, len 256 spear_smi_cpy_toio [620] dest c9070300, src c7be8b00, len 233 Unhandled fault: external abort on non-linefetch (0x808) at 0xc90703e8 [...] PC is at memcpy+0xcc/0x330
The above error occurs because the implementation of memcpy_toio() tries to optimize the number of I/O by writing 4 bytes at a time as much as possible, until there are less than 4 bytes left and then switches to word or byte writes.
Unfortunately, the specification states about the Write Burst mode:
"the next AHB Write request should point to the next incremented address and should have the same size (byte, half-word or word)"
This means ARM architecture implementation of memcpy_toio() cannot reliably be used blindly here. Workaround this situation by update the write path to stick to byte access when the burst length is not multiple of 4.
Fixes: f18dbbb1bfe0 ("mtd: ST SPEAr: Add SMI driver for serial NOR flash") Cc: Russell King linux@armlinux.org.uk Cc: Boris Brezillon boris.brezillon@collabora.com Cc: stable@vger.kernel.org Signed-off-by: Miquel Raynal miquel.raynal@bootlin.com ---
Changes in v2: ============== * This time I think the patch really fixes the problem: we use a memcpy_toio_b() function to force byte access only when needed. We don't use the _memcpy_toio() helper anymore as the fact that it is doing byte access is purely an implementation detail and is not part of the API, while the function is also flagged as "should be optimized". * One could argue that potentially memcpy_toio() does not ensure by design 4-bytes access only but I think it is good enough to use it in this case as the ARM implementation of this function is already extensively optimized. I also find clearer to use it than adding my own spear_smi_mempy_toio_l(). Please tell me if you disagree with this. * The volatile keyword has been taken voluntarily from the _memcpy_toio() implementation I was about to use previously.
drivers/mtd/devices/spear_smi.c | 25 ++++++++++++++++++++++++- 1 file changed, 24 insertions(+), 1 deletion(-)
diff --git a/drivers/mtd/devices/spear_smi.c b/drivers/mtd/devices/spear_smi.c index 986f81d2f93e..84b7487d781d 100644 --- a/drivers/mtd/devices/spear_smi.c +++ b/drivers/mtd/devices/spear_smi.c @@ -592,6 +592,19 @@ static int spear_mtd_read(struct mtd_info *mtd, loff_t from, size_t len, return 0; }
+static void spear_smi_memcpy_toio_b(volatile void __iomem *dest, + const void *src, size_t len) +{ + const unsigned char *from = src; + + while (len) { + len--; + writeb(*from, dest); + from++; + dest++; + } +} + static inline int spear_smi_cpy_toio(struct spear_smi *dev, u32 bank, void __iomem *dest, const void *src, size_t len) { @@ -614,7 +627,17 @@ static inline int spear_smi_cpy_toio(struct spear_smi *dev, u32 bank, ctrlreg1 = readl(dev->io_base + SMI_CR1); writel((ctrlreg1 | WB_MODE) & ~SW_MODE, dev->io_base + SMI_CR1);
- memcpy_toio(dest, src, len); + /* + * In Write Burst mode (WB_MODE), the specs states that writes must be + * incremental and of the same size, so we cannot use memcpy_toio() if + * the length is not 4-byte aligned because in order to increase the + * performances, it would proceed as much as possible with 4-byte access + * and potentially finish with smaller access sizes. + */ + if (len % sizeof(u32)) + spear_smi_memcpy_toio_b(dest, src, len); + else + memcpy_toio(dest, src, len);
writel(ctrlreg1, dev->io_base + SMI_CR1);