From: Conor Dooley conor.dooley@microchip.com
On Wed, 12 Jun 2024 18:33:31 +0800, Shengyu Qu wrote:
Currently, for JH7110 boards with EMMC slot, vqmmc voltage for EMMC is fixed to 1.8V, while the spec needs it to be 3.3V on low speed mode and should support switching to 1.8V when using higher speed mode. Since there are no other peripherals using the same voltage source of EMMC's vqmmc(ALDO4) on every board currently supported by mainline kernel, regulator-max-microvolt of ALDO4 should be set to 3.3V.
[...]
Applied to riscv-dt-fixes, thanks!
[1/1] riscv: dts: starfive: Set EMMC vqmmc maximum voltage to 3.3V on JH7110 boards https://git.kernel.org/conor/c/3c1f81a1b554
I was kinda holding out for a response for Emil, but I've applied this cos I'd like to get a fixes PR sent out later this week.
Thanks, Conor.