From: Subhash Jadavani subhashj@codeaurora.org
[ Upstream commit c7ccee224d2d551f712752c4a16947f6529d6506 ]
SDCC controller reset (SW_RST) during probe may trigger power irq if previous status of PWRCTL was either BUS_ON or IO_HIGH_V. So before we enable the power irq interrupt in GIC (by registering the interrupt handler), we need to ensure that any pending power irq interrupt status is acknowledged otherwise power irq interrupt handler would be fired prematurely.
Signed-off-by: Subhash Jadavani subhashj@codeaurora.org Signed-off-by: Vijay Viswanath vviswana@codeaurora.org Acked-by: Adrian Hunter adrian.hunter@intel.com Signed-off-by: Ulf Hansson ulf.hansson@linaro.org Signed-off-by: Sasha Levin alexander.levin@verizon.com --- drivers/mmc/host/sdhci-msm.c | 18 ++++++++++++++++++ 1 file changed, 18 insertions(+)
diff --git a/drivers/mmc/host/sdhci-msm.c b/drivers/mmc/host/sdhci-msm.c index fc73e56eb1e2..92c483ec6cb2 100644 --- a/drivers/mmc/host/sdhci-msm.c +++ b/drivers/mmc/host/sdhci-msm.c @@ -1251,6 +1251,21 @@ static int sdhci_msm_probe(struct platform_device *pdev) CORE_VENDOR_SPEC_CAPABILITIES0); }
+ /* + * Power on reset state may trigger power irq if previous status of + * PWRCTL was either BUS_ON or IO_HIGH_V. So before enabling pwr irq + * interrupt in GIC, any pending power irq interrupt should be + * acknowledged. Otherwise power irq interrupt handler would be + * fired prematurely. + */ + sdhci_msm_voltage_switch(host); + + /* + * Ensure that above writes are propogated before interrupt enablement + * in GIC. + */ + mb(); + /* Setup IRQ for handling power/voltage tasks with PMIC */ msm_host->pwr_irq = platform_get_irq_byname(pdev, "pwr_irq"); if (msm_host->pwr_irq < 0) { @@ -1260,6 +1275,9 @@ static int sdhci_msm_probe(struct platform_device *pdev) goto clk_disable; }
+ /* Enable pwr irq interrupts */ + writel_relaxed(INT_MASK, msm_host->core_mem + CORE_PWRCTL_MASK); + ret = devm_request_threaded_irq(&pdev->dev, msm_host->pwr_irq, NULL, sdhci_msm_pwr_irq, IRQF_ONESHOT, dev_name(&pdev->dev), host);