From: Shravya Kumbham shravya.kumbham@xilinx.com
[ Upstream commit b800528b97d0adc3a5ba42d78a8b0d3f07a31f44 ]
In xemaclite_open() function we are setting the max speed of emaclite to 100Mb using phy_set_max_speed() function so, there is no need to write the advertising registers to stop giga-bit speed and the phy_start() function starts the auto-negotiation so, there is no need to handle it separately using advertising registers. Remove the phy_read and phy_write of advertising registers in xemaclite_open() function.
Signed-off-by: Shravya Kumbham shravya.kumbham@xilinx.com Signed-off-by: Radhey Shyam Pandey radhey.shyam.pandey@xilinx.com Reviewed-by: Andrew Lunn andrew@lunn.ch Signed-off-by: Paolo Abeni pabeni@redhat.com Signed-off-by: Sasha Levin sashal@kernel.org --- drivers/net/ethernet/xilinx/xilinx_emaclite.c | 15 --------------- 1 file changed, 15 deletions(-)
diff --git a/drivers/net/ethernet/xilinx/xilinx_emaclite.c b/drivers/net/ethernet/xilinx/xilinx_emaclite.c index e29b5523b19b..f6ea4a0ad5df 100644 --- a/drivers/net/ethernet/xilinx/xilinx_emaclite.c +++ b/drivers/net/ethernet/xilinx/xilinx_emaclite.c @@ -932,8 +932,6 @@ static int xemaclite_open(struct net_device *dev) xemaclite_disable_interrupts(lp);
if (lp->phy_node) { - u32 bmcr; - lp->phy_dev = of_phy_connect(lp->ndev, lp->phy_node, xemaclite_adjust_link, 0, PHY_INTERFACE_MODE_MII); @@ -944,19 +942,6 @@ static int xemaclite_open(struct net_device *dev)
/* EmacLite doesn't support giga-bit speeds */ phy_set_max_speed(lp->phy_dev, SPEED_100); - - /* Don't advertise 1000BASE-T Full/Half duplex speeds */ - phy_write(lp->phy_dev, MII_CTRL1000, 0); - - /* Advertise only 10 and 100mbps full/half duplex speeds */ - phy_write(lp->phy_dev, MII_ADVERTISE, ADVERTISE_ALL | - ADVERTISE_CSMA); - - /* Restart auto negotiation */ - bmcr = phy_read(lp->phy_dev, MII_BMCR); - bmcr |= (BMCR_ANENABLE | BMCR_ANRESTART); - phy_write(lp->phy_dev, MII_BMCR, bmcr); - phy_start(lp->phy_dev); }