From: Stephan Gerhold stephan@gerhold.net
[ Upstream commit e6859ae8603c5946b8f3ecbd9b4f02b72955b9d0 ]
Commit fe2aff0c574d2 ("arm64: dts: qcom: msm8916: remove unit name for thermal trip points") removed the unit names for most of the thermal trip points defined in msm8916.dtsi, but missed to update the one for cpu0_1-thermal.
So why wasn't this spotted by "make dtbs_check"? Apparently, the name of the thermal zone is already invalid: thermal-zones.yaml specifies a regex of ^[a-zA-Z][a-zA-Z0-9\-]{1,12}-thermal$, so it is not allowed to contain underscores. Therefore the thermal zone was never verified using the DTB schema.
After replacing the underscore in the thermal zone name, the warning shows up:
apq8016-sbc.dt.yaml: thermal-zones: cpu0-1-thermal:trips: 'trip-point@0' does not match any of the regexes: '^[a-zA-Z][a-zA-Z0-9\-_]{0,63}$', 'pinctrl-[0-9]+'
Fix up the thermal zone names and remove the unit name for the trip point.
Cc: Amit Kucheria amit.kucheria@linaro.org Fixes: fe2aff0c574d2 ("arm64: dts: qcom: msm8916: remove unit name for thermal trip points") Signed-off-by: Stephan Gerhold stephan@gerhold.net Link: https://lore.kernel.org/r/20200915071221.72895-3-stephan@gerhold.net Signed-off-by: Bjorn Andersson bjorn.andersson@linaro.org Signed-off-by: Sasha Levin sashal@kernel.org --- arch/arm64/boot/dts/qcom/msm8916.dtsi | 6 +++--- 1 file changed, 3 insertions(+), 3 deletions(-)
diff --git a/arch/arm64/boot/dts/qcom/msm8916.dtsi b/arch/arm64/boot/dts/qcom/msm8916.dtsi index 67cae5f9e47e6..c2fb9f7291c5e 100644 --- a/arch/arm64/boot/dts/qcom/msm8916.dtsi +++ b/arch/arm64/boot/dts/qcom/msm8916.dtsi @@ -229,14 +229,14 @@ pmu { };
thermal-zones { - cpu0_1-thermal { + cpu0-1-thermal { polling-delay-passive = <250>; polling-delay = <1000>;
thermal-sensors = <&tsens 5>;
trips { - cpu0_1_alert0: trip-point@0 { + cpu0_1_alert0: trip-point0 { temperature = <75000>; hysteresis = <2000>; type = "passive"; @@ -259,7 +259,7 @@ map0 { }; };
- cpu2_3-thermal { + cpu2-3-thermal { polling-delay-passive = <250>; polling-delay = <1000>;