On 30/09/2022 22:12, Doug Anderson wrote:
Hi,
On Fri, Sep 30, 2022 at 11:22 AM Krzysztof Kozlowski krzysztof.kozlowski@linaro.org wrote:
The pin configuration (done with generic pin controller helpers and as expressed by bindings) requires children nodes with either:
- "pins" property and the actual configuration,
- another set of nodes with above point.
The qup_spi2_default pin configuration used second method - with a "pinmux" child.
Fixes: 8d23a0040475 ("arm64: dts: qcom: db845c: add Low speed expansion i2c and spi nodes") Cc: stable@vger.kernel.org Signed-off-by: Krzysztof Kozlowski krzysztof.kozlowski@linaro.org
Not tested on hardware.
arch/arm64/boot/dts/qcom/sdm845-db845c.dts | 4 +++- 1 file changed, 3 insertions(+), 1 deletion(-)
diff --git a/arch/arm64/boot/dts/qcom/sdm845-db845c.dts b/arch/arm64/boot/dts/qcom/sdm845-db845c.dts index 132417e2d11e..a157eab66dee 100644 --- a/arch/arm64/boot/dts/qcom/sdm845-db845c.dts +++ b/arch/arm64/boot/dts/qcom/sdm845-db845c.dts @@ -1123,7 +1123,9 @@ &wifi {
/* PINCTRL - additions to nodes defined in sdm845.dtsi */ &qup_spi2_default {
drive-strength = <16>;
pinmux {drive-strength = <16>;};The convention on Qualcomm boards of this era is that muxing (setting the function) is done under a "pinmux" node and, unless some of the pins need to be treated differently like for the UARTs, configuration (bias, drive strength, etc) is done under a "pinconf" subnode.
Yes, although this was not expressed in bindings.
I believe that the "pinconf" subnode also needs to replicate the list of pins, or at least that's what we did everywhere else on sdm845 / sc7180.
Yes.
Thus to match conventions, I assume you'd do:
&qup_spi2_default { pinconf {
No, because I want a convention of all pinctrl bindings and drivers, not convention of old pinctrl ones. The new ones are already moved or being moved to "-state" and "-pins". In the same time I am also unifying the requirement of "function" property - enforcing it in each node, thus "pinconf" will not be valid anymore.
pins = "gpio27", "gpio28", "gpio29", "gpio30"; drive-strength = <16>;}; };
We've since moved away from this to a less cumbersome approach, but for "older" boards like db845c we should probably match the existing convention, or have a flag day and change all sdm845 boards over to the new convention.
That's what my next patchset from yesterday was doing. Unifying the bindings with modern bindings and converting DTS to match them.
https://lore.kernel.org/linux-devicetree/20220930200529.331223-1-krzysztof.k...
Best regards, Krzysztof