From: Mikhail Lappo mikhail.lappo@esrlabs.com
When device boots with T > T_trip_1 and requests interrupt, the race condition takes place. The interrupt comes before THERMAL_DEVICE_ENABLED is set. This leads to an attempt to reading sensor value from irq and disabling the sensor, based on the data->mode field, which expected to be THERMAL_DEVICE_ENABLED, but still stays as THERMAL_DEVICE_DISABLED. Afher this issue sensor is never re-enabled, as the driver state is wrong.
Fix this problem by setting the 'data' members prior to requesting the interrupts.
Fixes: 37713a1e8e4c ("thermal: imx: implement thermal alarm interrupt handling") Cc: stable@vger.kernel.org Signed-off-by: Mikhail Lappo mikhail.lappo@esrlabs.com Signed-off-by: Fabio Estevam fabio.estevam@nxp.com --- drivers/thermal/imx_thermal.c | 6 +++--- 1 file changed, 3 insertions(+), 3 deletions(-)
diff --git a/drivers/thermal/imx_thermal.c b/drivers/thermal/imx_thermal.c index a67781b..ee3a215 100644 --- a/drivers/thermal/imx_thermal.c +++ b/drivers/thermal/imx_thermal.c @@ -637,6 +637,9 @@ static int imx_thermal_probe(struct platform_device *pdev) regmap_write(map, TEMPSENSE0 + REG_CLR, TEMPSENSE0_POWER_DOWN); regmap_write(map, TEMPSENSE0 + REG_SET, TEMPSENSE0_MEASURE_TEMP);
+ data->irq_enabled = true; + data->mode = THERMAL_DEVICE_ENABLED; + ret = devm_request_threaded_irq(&pdev->dev, data->irq, imx_thermal_alarm_irq, imx_thermal_alarm_irq_thread, 0, "imx_thermal", data); @@ -649,9 +652,6 @@ static int imx_thermal_probe(struct platform_device *pdev) return ret; }
- data->irq_enabled = true; - data->mode = THERMAL_DEVICE_ENABLED; - return 0; }