On 2025-01-15 12:57, Shuah Khan wrote:
On 1/14/25 17:45, Mathieu Desnoyers wrote:
On 2025-01-14 19:14, Shuah Khan wrote:
On 1/14/25 07:51, Mathieu Desnoyers wrote:
When porting librseq commit:
commit c7b45750fa85 ("Adapt to glibc __rseq_size feature detection")
from librseq to the kernel selftests, the following line was missed at the end of rseq_init():
rseq_size = get_rseq_kernel_feature_size();
which effectively leaves rseq_size initialized to -1U when glibc does not have rseq support. glibc supports rseq from version 2.35 onwards.
In a following librseq commit
commit c67d198627c2 ("Only set 'rseq_size' on first thread registration")
to mimic the libc behavior, a new approach is taken: don't set the feature size in 'rseq_size' until at least one thread has successfully registered. This allows using 'rseq_size' in fast-paths to test for both registration status and available features. The caveat is that on libc either all threads are registered or none are, while with bare librseq it is the responsability of the user to register all threads using rseq.
This combines the changes from the following librseq commits:
commit c7b45750fa85 ("Adapt to glibc __rseq_size feature detection") commit c67d198627c2 ("Only set 'rseq_size' on first thread registration")
Fixes: 73a4f5a704a2 ("selftests/rseq: Fix mm_cid test failure")
Fixed this commit id commit c7b45750fa85 ("Adapt to glibc __rseq_size feature detection")
Just pointing out that you did the right thing in the commit that ends up in linux-kselftest next:
https://git.kernel.org/pub/scm/linux/kernel/git/shuah/linux-kselftest.git/co...
Fixes: a0cc649353bb ("selftests/rseq: Fix mm_cid test failure")
Which is fine.
Thanks!
Mathieu
Signed-off-by: Mathieu Desnoyers mathieu.desnoyers@efficios.com
Hi Mathieu,
Can you double check these commits and make sure these are right ones in the mainline rc7?
I am seeing "Unknown commit id" warnings on all of these - my repo is at 6.13 rc7
This is because those are commits in the librseq project at https://git.kernel.org/pub/scm/libs/librseq/librseq.git/ which is a different tree from the Linux kernel. I am not sure what is the preferred approach when citing a commit ID from a different project ?
I've been keeping both rseq selftests and librseq in sync since 2018. I plan to eventually add a dependency of the rseq selftests on librseq, but this cannot happen until we freeze the API and cut a librseq release.
This was premature before we reached the major milestone of having extensible rseq support in glibc.
Now that it's merged into glibc (as of last week), we can start looking forward to a librseq release, which should eventually eliminate code duplication with rseq selftests.
Perhaps we should add a Link: to the librseq repository ?
Also would you like to add Reported-by for Raghavendra Rao Ananta?
Added. The patch is now in linux-kselftest next
thanks, -- Shuah