From: Max Uvarov muvarov@gmail.com
Commit 333061b924539c0de081339643f45514f5f1c1e6 upstream.
For supporting 10Mps speed in SGMII mode DP83867_10M_SGMII_RATE_ADAPT bit of DP83867_10M_SGMII_CFG register has to be cleared by software. That does not affect speeds 100 and 1000 so can be done on init.
Signed-off-by: Max Uvarov muvarov@gmail.com Cc: Heiner Kallweit hkallweit1@gmail.com Cc: Florian Fainelli f.fainelli@gmail.com Cc: Andrew Lunn andrew@lunn.ch Signed-off-by: David S. Miller davem@davemloft.net [ adapted for kernels without phy_modify_mmd ] Signed-off-by: Adrian Bunk bunk@kernel.org --- - already in 5.3 - applies and builds against 4.14 and 4.19 - tested with 4.14 --- drivers/net/phy/dp83867.c | 19 +++++++++++++++++++ 1 file changed, 19 insertions(+)
diff --git a/drivers/net/phy/dp83867.c b/drivers/net/phy/dp83867.c index 12b09e6e03ba..81106314e6da 100644 --- a/drivers/net/phy/dp83867.c +++ b/drivers/net/phy/dp83867.c @@ -37,6 +37,8 @@ #define DP83867_STRAP_STS1 0x006E #define DP83867_RGMIIDCTL 0x0086 #define DP83867_IO_MUX_CFG 0x0170 +#define DP83867_10M_SGMII_CFG 0x016F +#define DP83867_10M_SGMII_RATE_ADAPT_MASK BIT(7)
#define DP83867_SW_RESET BIT(15) #define DP83867_SW_RESTART BIT(14) @@ -283,6 +285,23 @@ static int dp83867_config_init(struct phy_device *phydev) } }
+ if (phydev->interface == PHY_INTERFACE_MODE_SGMII) { + /* For support SPEED_10 in SGMII mode + * DP83867_10M_SGMII_RATE_ADAPT bit + * has to be cleared by software. That + * does not affect SPEED_100 and + * SPEED_1000. + */ + val = phy_read_mmd(phydev, DP83867_DEVADDR, + DP83867_10M_SGMII_CFG); + val &= ~DP83867_10M_SGMII_RATE_ADAPT_MASK; + ret = phy_write_mmd(phydev, DP83867_DEVADDR, + DP83867_10M_SGMII_CFG, val); + + if (ret) + return ret; + } + /* Enable Interrupt output INT_OE in CFG3 register */ if (phy_interrupt_is_valid(phydev)) { val = phy_read(phydev, DP83867_CFG3);