From: Sven Eckelmann sven@narfation.org
commit 7492ffc90fa126afb67d4392d56cb4134780194a upstream.
The CONSOLE_POLLING mode is used for tools like k(g)db. In this kind of setup, it is often sharing a serial device with the normal system console. This is usually no problem because the polling helpers can consume input values directly (when in kgdb context) and the normal Linux handlers can only consume new input values after kgdb switched back.
This is not true anymore when RX DMA is enabled for UARTDM controllers. Single input values can no longer be received correctly. Instead following seems to happen:
* on 1. input, some old input is read (continuously) * on 2. input, two old inputs are read (continuously) * on 3. input, three old input values are read (continuously) * on 4. input, 4 previous inputs are received
This repeats then for each group of 4 input values.
This behavior changes slightly depending on what state the controller was when the first input was received. But this makes working with kgdb basically impossible because control messages are always corrupted when kgdboc tries to parse them.
RX DMA should therefore be off when CONSOLE_POLLING is enabled to avoid these kind of problems. No such problem was noticed for TX DMA.
Fixes: 99693945013a ("tty: serial: msm: Add RX DMA support") Cc: stable@vger.kernel.org Signed-off-by: Sven Eckelmann sven@narfation.org Link: https://lore.kernel.org/r/20211113121050.7266-1-sven@narfation.org Signed-off-by: Greg Kroah-Hartman gregkh@linuxfoundation.org --- drivers/tty/serial/msm_serial.c | 3 +++ 1 file changed, 3 insertions(+)
--- a/drivers/tty/serial/msm_serial.c +++ b/drivers/tty/serial/msm_serial.c @@ -611,6 +611,9 @@ static void msm_start_rx_dma(struct msm_ u32 val; int ret;
+ if (IS_ENABLED(CONFIG_CONSOLE_POLL)) + return; + if (!dma->chan) return;