From: Hugo Villeneuve hvilleneuve@dimonoff.com
When configuring a pin as an output pin with a value of logic 0, we end up as having a value of logic 1 on the output pin. Setting a logic 0 a second time (or more) after that will correctly output a logic 0 on the output pin.
By default, all GPIO pins are configured as inputs. When we enter sc16is7xx_gpio_direction_output() for the first time, we first set the desired value in IOSTATE, and then we configure the pin as an output. The datasheet states that writing to IOSTATE register will trigger a transfer of the value to the I/O pin configured as output, so if the pin is configured as an input, nothing will be transferred.
Therefore, set the direction first in IODIR, and then set the desired value in IOSTATE.
This is what is done in NXP application note AN10587.
Fixes: dfeae619d781 ("serial: sc16is7xx") Cc: stable@vger.kernel.org Signed-off-by: Hugo Villeneuve hvilleneuve@dimonoff.com Reviewed-by: Lech Perczak lech.perczak@camlingroup.com Tested-by: Lech Perczak lech.perczak@camlingroup.com --- drivers/tty/serial/sc16is7xx.c | 11 ++++++++++- 1 file changed, 10 insertions(+), 1 deletion(-)
diff --git a/drivers/tty/serial/sc16is7xx.c b/drivers/tty/serial/sc16is7xx.c index edc83f5f6340..7a9b91f0c710 100644 --- a/drivers/tty/serial/sc16is7xx.c +++ b/drivers/tty/serial/sc16is7xx.c @@ -1340,9 +1340,18 @@ static int sc16is7xx_gpio_direction_output(struct gpio_chip *chip, state |= BIT(offset); else state &= ~BIT(offset); - sc16is7xx_port_write(port, SC16IS7XX_IOSTATE_REG, state); + + /* + * If we write IOSTATE first, and then IODIR, the output value is not + * transferred to the corresponding I/O pin. + * The datasheet states that each register bit will be transferred to + * the corresponding I/O pin programmed as output when writing to + * IOSTATE. Therefore, configure direction first with IODIR, and then + * set value after with IOSTATE. + */ sc16is7xx_port_update(port, SC16IS7XX_IODIR_REG, BIT(offset), BIT(offset)); + sc16is7xx_port_write(port, SC16IS7XX_IOSTATE_REG, state);
return 0; }