From: Jan Schmidt jan@centricular.com
If an endpoint is encountered that returns USB3_LPM_DEVICE_INITIATED, keep checking further endpoints, as there might be periodic endpoints later that return USB3_LPM_DISABLED due to shorter service intervals.
Without this, the code can set too high a maximum-exit-latency and prevent the use of multiple USB3 cameras that should be able to work.
Cc: stable@vger.kernel.org Signed-off-by: Jan Schmidt jan@centricular.com Tested-by: Philipp Zabel p.zabel@pengutronix.de Signed-off-by: Mathias Nyman mathias.nyman@linux.intel.com --- drivers/usb/host/xhci.c | 8 ++++---- 1 file changed, 4 insertions(+), 4 deletions(-)
diff --git a/drivers/usb/host/xhci.c b/drivers/usb/host/xhci.c index aed5a65f25bd..a5ba5ace3d00 100644 --- a/drivers/usb/host/xhci.c +++ b/drivers/usb/host/xhci.c @@ -4674,12 +4674,12 @@ static int xhci_update_timeout_for_endpoint(struct xhci_hcd *xhci, alt_timeout = xhci_call_host_update_timeout_for_endpoint(xhci, udev, desc, state, timeout);
- /* If we found we can't enable hub-initiated LPM, or + /* If we found we can't enable hub-initiated LPM, and * the U1 or U2 exit latency was too high to allow - * device-initiated LPM as well, just stop searching. + * device-initiated LPM as well, then we will disable LPM + * for this device, so stop searching any further. */ - if (alt_timeout == USB3_LPM_DISABLED || - alt_timeout == USB3_LPM_DEVICE_INITIATED) { + if (alt_timeout == USB3_LPM_DISABLED) { *timeout = alt_timeout; return -E2BIG; }