Hi Johan,
On Tue, Apr 30, 2024 at 9:07 AM Johan Hovold johan@kernel.org wrote:
On Tue, Apr 30, 2024 at 06:22:26PM +0530, Janaki Ramaiah Thota wrote:
On 4/30/2024 12:37 PM, Johan Hovold wrote:
On Mon, Apr 29, 2024 at 01:31:53PM -0400, Luiz Augusto von Dentz wrote:
Anyway the fact that firmware loading itself is programming a potentially duplicated address already seems wrong enough to me, either it shall leave it as 00... or set a valid address otherwise we always risk missing yet another duplicate address being introduced and then used over the air causing all sorts of problems for users.
So to be clear, QCA firmware shall never attempt to flash anything other than 00:00:00:00:00:00 if you don't have a valid and unique identity address, so we can get rid of this table altogether.
Yes agree with this point. BD address should be treated as invalid if it is 00:00:00:00:00:00.
We all agree on that.
NVM Tag 2: bd address is default BD address (other than 0), should be configured as valid address and as its not unique address and it will be same for all devices so mark it is configured but still allow user-space to change the address.
But here we disagree. A non-unique address is not a valid one as it will cause collisions if you have more than one such controller.
I understand that this may be convenient/good enough for developers in some cases, but this can hurt end users that do not realise why things break.
And a developer can always configure an address manually or patch the driver as needed for internal use.
Are there any other reasons that makes you want to keep the option to configure the device address through NVM files? I'm assuming you're not relying on patching NVM files to provision device-specific addresses after installation on target?
Exactly, a duplicated address is not a valid public/identity address.
Regarding them already been in use, we will need to have it fixed one way or the other, so it is better to change whatever it comer within the firmware file to 00:00:00:00:00:00 and have it setup a proper address after that rather than have a table that detect the use of duplicated addresses since the result would be the same since userspace stores pairing/devices based on adapter addresses they will be lost and the user will need to pair its peripherals again, so my recommendation is that this is done via firmware update rather than introducing a table containing duplicate addresses.
That said it seems the patch in this thread actually reads the address with use of EDL_TAG_ID_BD_ADDR and then proceed to check if that is what the controller returns as address, while that is better than having a table I think there is still a risk that the duplicated address gets used on older kernels if that is not updated in the firmware directly, anyway perhaps we shall be doing both so we capture both cases where duplicated addresses are used or when BDADDR_ANY is.